The intermediate energy storage system is very necessary for the standalone multi-source renewable energy system to increase stability, reliability of supply, and power quality. Among the most practical energy storage solutions is combining supercapacitors and chemical batteries. However, the major problem in this kind of application is the design of the power management, as well as the control scheme of hybrid energy storage systems. The focal purpose of this paper is to develop a novel approach to control DC bus voltage based on the reference power's frequency decomposition. This paper uses a storage system combined of batteries and supercapacitors. These later are integrated in the multi-source renewable energy system to supply an AC load. This technique uses the low-pass filters' properties to control the DC bus voltage by balancing the generated green power and the fluctuating load. The hybrid storage system regulates power fluctuations by absorbing surplus power and providing required power. The results show good performances of the proposed control scheme, such as low battery current charge/discharge rates, lower current stress level on batteries, voltage control improvements, which lead to increase the battery life.
1 August 2025 in International Journal of Electrical and Computer Engineering (IJECE)
Research on thin-film solar cells based on CuInSe2 has demonstrated the potential of this compound for photovoltaic conversion. The introduction of gallium as a substitute for indium has led to the creation of the CuInxGa1-xSe2 (CIGS) structure, which could serve as one of the foundational materials for high-performance solar cells. This paper focuses on modelling the bifacial back surface field (BSF) solar cell. We took the CdS/CIGS thin-film structure as an application example to optimize, through simulation, the physical-electronic and geometric parameters of the various layers of the cell. Our study has led us to interesting results that clearly show that the performance of the cell is precisely controlled by the space charge region associated with the CIGS absorber layer, which is promising for research in photovoltaics due to its high absorption coefficient and the ability to vary its bandgap, allowing for increased conversion efficiency. The high-doped P+ layer (Wbsf) enhances the total photocurrent of the bifacial.
12 October 2026 in Journal of Elecetrical Engineering and Renewable Energies Development
This paper presents a detailed investigation of a solar photovoltaic water pumping system (SPVWPS) driven by a three-phase induction motor (IM). The control scheme relies on three cooperating fuzzy regulators whose combined action aims to increase the energy efficiency and optimize the dynamic behavior of the installation. The first regulator, based on fuzzy logic and maximum power point tracking (FLC-MPPT), maintains the photovoltaic generator at its optimal operating point, thereby extracting the maximum available power irrespective of the prevailing weather. A second regulator implements a fuzzy direct torque control (FL-DTC), which enables precise and rapid regulation of the motor's torque and flux, while mitigating electromagnetic torque ripple and improving the quality of the electrical waveforms. A third fuzzy unit regulates the rotor speed, ensuring a faster dynamic response, better steady-state stability, and self-adaptation to load changes. The complete system was built and simulated in the MATLAB/Simulink environment in order to assess the proposed strategy. The obtained results demonstrate clear improvements in terms of settling time, stability and waveform quality as well as a higher flow rate that is a direct consequence of more precise motor speed regulation.
1 June 2026 in International Journal of Power Electronics and Drive Systems (IJPEDS)
Power systems face growing challenges of voltage instability, line congestion, and increased losses under rising demand. This study proposes a coordinated approach using two flexible AC transmission system (FACTS) devices: the static var compensator (SVC) and the thyristor controlled series capacitor (TCSC), together with photovoltaic (PV) generation, to enhance grid performance. The IEEE 30 bus test system is analyzed under normal and increased load conditions (5%, 10%, 15% load growth). Results show that coordinated SVC TCSC operation improves voltage profiles, reduces critical line loading by 14%, and lowers active and reactive losses by 10% and 23.8%, respectively, in the base case. Under a 15% load increase, integrating a 25 MW PV system with the coordinated FACTS restores the minimum voltage to 0.95 p.u., reduces line congestion by 27%, and decreases active and reactive losses by 35.5% and 53.5%. The combined FACTS PV strategy proves essential for maintaining stability and efficiency under high load growth. This integrated approach provides practical guidance for transmission operators toward resilient, loss aware, and renewable integrated smart grids.
1 January 2026 in ITEGAM-Journal of Engineering and Technology for Industrial Applications (ITEGAM-JETIA)
This paper presents an innovative approach to optimising the reliability of electrical systems associated with wind farms by integrating advanced methods, including the Universal Moment Generating Function (UMGF), artificial neural networks (ANN), and the Harmony Search (HS) algorithm. The study focuses on modelling multi-state systems to address the complexity of wind energy production, which involves stochastic variability and degradation phenomena. The proposed methodology combines reliability assessment techniques with cost constraints to determine the most economical system configuration that meets specified reliability levels. Through simulations involving various subsystems (wind turbines, transformers, transmission lines), the authors demonstrate that their hybrid approach effectively balances investment costs and system reliability. The results indicate that maximizing reliability incurs higher costs, with the optimal compromise found at a reliability level around 97%, corresponding to a minimal investment of approximately 30,400 MDA (Million Dinars Algerian). Overall, this integrated optimization framework offers a practical, flexible solution for designing cost-effective, reliable wind energy systems, contributing valuable insights to renewable energy planning and reliability engineering.