Solar photovoltaic (PV) connection with the grid becomes more prevalent in distributed generation, and the DC grid contributes a significantly to the distributing system. The current study focuses on combining rooftop solar with the DC microgrid. A high-gain DC–DC converter for photovoltaic systems (HGBC-PVS) is proposed in this article to link two lower-voltage photovoltaic panels to a higher-voltage network. The designed converter with low-rating switches generates improved values of voltage gain and efficiency. To gain the most power out of solar modules, Maximum Power Point Tracking (MPPT) is used, which employs the Adaptive Incremental Conductance approach. It extracts the maximum power, thereby facilitating efficient converter operation and generating optimal outputs. The simulation outcomes in terms of voltage, inductor current, output efficiency, and voltage gain are computed, and the outcomes show the significance of the introduced topology. The efficacy of the introduced work is proved by the comparison of measured outputs with the computed outputs for various parameters.
In a DC microgrid, droop control is the most common and widely used strategy for managing the power flow from sources to loads. Conventional droop control has some limitations such as poor voltage regulation and improper load sharing between converters during unequal source voltages, different cable resistances, and load variations. This paper addressed the limitations of conventional droop control by proposing a simple adaptive droop control technique. The proposed adaptive droop control method was designed based on mathematical calculations, adjusting the droop parameters accordingly. The primary objective of the proposed adaptive droop controller was to improve the performance of the low-voltage DC microgrid by maintaining proper load sharing, reduced circulating current, and better voltage regulation. The effectiveness of the proposed methodology was verified by conducting simulation and experimental studies.
A peak shaving approach in selected industrial loads helps minimize power usage during high demand hours, decreasing total energy expenses while improving grid stability. A battery energy storage system (BESS) can reduce peak electricity demand in distribution networks. Quasi-dynamic load flow analysis (QLFA) accurately assesses the maximum loading conditions in distribution networks by considering factors such as load profiles, system topology, and network constraints. Achieving maximum peak shaving requires optimizing battery charging and discharging cycles based on real-time energy generation and consumption patterns. Seamless integration of battery storage with solar photovoltaic (PV) systems and industrial processes is essential for effective peak shaving strategies. This paper proposes a model predictive control (MPC) scheme that can effectively perform peak shaving of the total industrial load. Adopting an MPC-based algorithm design framework enables the development of an effective control strategy for complex systems. The proposed MPC methodology was implemented and tested on the Indian Utility 29 Node Distribution Network (IU29NDN) using the DIgSILENT Power Factory environment. Additionally, the analysis encompasses technical and economic results derived from a simulated storage operation and, taking Puducherry State Electricity Department tariff details, provides significant insights into the application of this method.
Sustainable energy solutions from photovoltaic (PV)-based direct current (DC) microgrids (MG) encounter issues in maintaining voltage stability and power-sharing efficiency during dynamic demand fluctuation. System instability and poor performance are caused by traditional droop control methods, which rely on predetermined parameters and are unable to handle fluctuating loads. Due to dynamic load circumstances, DC microgrids powered by PV may experience voltage fluctuations, power imbalances, and significant power losses. Traditional droop control is unstable and inefficient because it cannot make real-time corrections. Microgrid stability requires constant droop optimization. Metaheuristic-Tuned Droop Control (MTDC) uses the Self-Adaptive Particle Swarm Optimization (SA-PSO) technique to calculate the dynamic droop coefficient. With an inertia weight adjustment method, SA-PSO improves convergence and flexibility. Optimization goals include minimizing power loss, enhancing power-sharing accuracy, and mitigating voltage fluctuations. This study simulates the proposed approach using MATLAB/Simulink under various stress conditions to verify its effectiveness. Unlike traditional droop control, MTDC minimizes voltage fluctuation, improves power-sharing accuracy, and lowers power losses. Metaheuristic optimization improves PV-based DC microgrid control. Systems become more stable, respond faster, and withstand disturbances. According to this research, adaptive droop control can enhance the efficiency and reliability of microgrids powered by renewable energy.