Acoustic sensors with ultrahigh sensitivity, broadband response, and high resolution are essential for high-precision nondestructive weak signal detection technology. In this paper, based on the size effect of an ultrahigh-quality (Q) calcium fluoride (CaF2) resonator, a weak acoustic signal is detected by the dispersive response regime in which an acoustic, elastic wave modulates the geometry and is converted to a resonance frequency shift. Through the structural design of the resonator, the sensitivity reaches 11.54 V/Pa at 10 kHz in the experiment. To our knowledge, the result is higher than that of other optical resonator acoustic sensors. We further detected a weak signal as low as 9.4 µPa/Hz1/2, which greatly improved the detection resolution. With a good directionality of 36.4 dB and a broadband frequency response range of 20 Hz–20 kHz, the CaF2 resonator acoustic sensing system can not only acquire and reconstruct speech signals over a long distance but also accurately identify and separate multiple voices in noisy environments. This system shows high performance in weak sound detection, sound source localization, sleep monitoring, and many other voice interaction applications.
Whispering gallery mode (WGM) crystalline resonator is an excellent platform for acoustic sensing because the quality ( Q ) factor of 10 11 can theoretically increase sensitivity by more than three orders of magnitude. However, ultrahigh sensitivity and wide dynamic response range cannot be achieved simultaneously, due to the extremely narrow linewidth and small linear range of ultrahigh- Q mode. Based on the multi-mode calcium fluoride (CaF 2 ) resonator supports different Q (10 6 ∼10 9 ), fast switching with ultrahigh sensitivity and wide dynamic response range can be achieved by locking modes with different Q . The mode with Q of 5.13 × 10 8 shows a high sensitivity of 280 mV/Pa at 1 kHz frequency, which is better than other WGM acoustic sensors currently reported. When switching to the lower- Q of 6.24 × 10 6 , the dynamic response range is improved by 38.3 dB.
Acceleration measurement is widely used in military, civil, and industrial applications. However, it is difficult for traditional microelectromechanical systems (MEMS) accelerometers to combine high sensitivity and large bandwidth. Therefore, we propose a Fabry-Perot (F-P) optomechanical accelerometer based on a suspended Si 3 N 4 membrane resonator. We develop an optical excitation scheme to investigate the response of the resonator and a separate laser interferometry measurement system to achieve highly sensitive displacement readout. The single thermomechanical vibration mode of the resonator enables precise conversion from displacement to acceleration. The accelerometer exhibited an acceleration sensitivity of 0.72 μg/√Hz at 412.59 kHz, reaching the thermomechanical limit. Then, we focused on studying the relationship between optical power and optical shot noise and reducing the shot noise by tuning the optical power, which increased the accelerometer’s 3 dB bandwidth by an order of magnitude from 1.56 kHz to 15.34 kHz. The displacement sensitivity of the measurement system is optimized to 2.5 fm/√Hz. This sensing platform and optical power tuning method lay a certain foundation for the development of high frequency, high sensitivity, and broadband optomechanical accelerometers.
6 February 2024 in Journal of Lightwave Technology
The parity-time (PT) -symmetric gyroscope system is able to solve the problem of achieving high sensitivity in a reduced footprint for optical gyroscopes by manipulating the physical properties of the exceptional points (EP). Nevertheless, its system tuning is intricate and hard to read, which hinders its practical implementation. On the contrary, the real frequency splitting and simple tuning of the anti-parity-time(APT)-symmetric gyroscope system represents a viable alternative to the conventional PT-symmetric gyroscope. However, due to the high fabrication process required for virtual coupling, no experiments have been reported. To achieve this goal, we utilize three resonant cavities in series to construct the APT angular rate sensor system, with the assistance of lossy cavity to meet the imaginary coupling requirement. Due to the much more stable nature of resonant cavities compared to waveguides, the system has greater robustne. Simultaneously, we established the cavity photomechanics model and the angular rate sensing model of the APT system, and tested the response of the system under different frequency differences. The experiment findings demonstrate that the mode splitting in this system is 4 times greater than that of the conventional device. Additionally, the transmission spectrum amplitude displays a highly sensitive response to perturbation during the unbroken period, with a 7 times improvement compared to the first-order system. This provides the basis for experimental validation of the pioneering anti-PT gyroscope.
Whispering-gallery mode (WGM) optical resonators with ultra-high optical quality factor (Q) and small mode volume (V) are one of the most promising platforms for magnetic sensing. However, the low conversion efficiency between the magnetic signal and the optical resonator makes it difficult to break through the pico-Tesla (pT) level of sensitivity, limiting its performance in applications. Here, we propose an ultra-high Q calcium fluoride (CaF 2 ) WGM resonator with an asymmetric wedge structure for magnetic sensing. Theoretically, the structural parameters of the asymmetric wedge significantly regulate the deformation of the resonator under magnetic induction. Interestingly, certain structural parameters correspond to zero deformation. Based on this phenomenon, an optimized sensitivity of 0.93 pT/Hz 1/2 at 654.2 kHz is obtained utilizing the resonator with Q of 8.6×10 8 . Moreover, the system demonstrated a highly sensitive response from 10 kHz to 1 MHz. The CaF 2 resonator magnetic sensor based on asymmetric wedge structure will play an important role in areas such as magnetic anomaly detection and mineral exploration.
The whispering gallery mode cavities with high quality factor as highly sensitive acoustic sensors, due to narrow linewidth is capable of detecting slight external disturbances. However, spherical cavities pose a challenge in the directivity of acoustic detection caused by structure symmetry. Here, a lever acoustic sensor combined with flexible polymer cavity is proposed. The copper sheet as the acoustic signal receiver provides a good directivity. As a signal readout unit, the flexible characteristics of polymer cavity with the quality factor of 10 5 increase the signal response, which is fabricated by superoleophobic substrates. An optical fiber acts as a cantilever to transfer energy between them. Frequency responses and acoustic vibrations are collected between 200 Hz and 10 kHz in the experiment. The maximum sensitivity and minimum detectable acoustic pressure at 4 kHz are 23.58 mV/Pa and 1.38 mPa/Hz 1/2 , respectively. The good directivity with a notch depth of 16 dB in the directional map is obtained which shows a promising candidate for the applications.