In this work, the distribution and evolution of micro-defect in single crystal γ-TiAl alloy during nanometer cutting is studied by means of molecular dynamics simulation. Nanometer cutting is performed along two typical crystal directions: and . A machined surface, system potential energy, amorphous layer, lattice deformation and the formation mechanism of chip are discussed. The results indicate that the intrinsic stacking fault, dislocation loop and atomic cluster are generated below the machined surface along the cutting crystal directions. In particular, the Stacking Fault Tetrahedron (SFT) is generated inside the workpiece when the cutting crystal direction is along . However, a “V”-shape dislocation loop is formed in the workpiece along . Furthermore, atomic distribution of the machined surface indicates that the surface quality along is better than that along . In a certain range, the thickness of the amorphous layer increases gradually with the rise of cutting force during nanometric cutting process.
Cold deformation behavior of polycrystalline metallic material is affected by intrinsic defects such as dislocations, voids, inclusions etc. Existing studies on + two-phase Ti–Al alloy cover about deformation behavior mainly on macro scale. This paper focuses on the cold deformation mechanism of two-phase Ti–Al alloy at micro scale, and the role of voids in deformation process. Molecular dynamics simulations were performed to study the evolution of micro structure of material under uniaxial tension. Interaction between spherical nano voids with different size and position was also examined in the simulation. The results show that (1) In elastic stage, deformation of the two-phase is coordinated, but is more deformable; (2) In plastic stage, phase is the major dislocation source in two-phase alloy; (3) voids detracts the strength of the two-phase alloy, while the position of void affect the degree of this subtraction, voids located at the boundary of / phase have significant detraction to strength.
11 March 2025 in Journal of Materials Research and Technology
In this paper, molecular dynamics (MD) simulations are performed to study the influence of residual stress on fracture behavior in γ -TiAl alloy with ∑3(111) twin boundaries. The tensile processes are simulated at 1, 300, 1050 K after the residual stress is introduced by prepressing. The evolution of microdefects during tensile fracture is observed, and the distribution of residual stress in three direction is characterized. Results show that the introduced residual stress is symmetrically distributed on both sides of ∑3(111) twin boundaries. The residual compressive stress can prevent the nucleation of micro-cracks and increase the yield strength. The fracture mode of the γ -TiAl alloy with ∑3(111) twin boundaries during tensile load at 1 K is the nucleation of microcracks at grain boundaries followed by intergranular fracture. The ∑3(111) twin boundaries have good thermal stability. The residual compressive stress is completely released and the amplitude of residual tensile stress increases at 1050 K, and the γ -TiAl alloy with ∑3(111) twin boundaries exhibits good ductility.