Magnesium-based alloys remain poorly researched, particularly regarding their behavior and resistance under hydrodynamic loading conditions. Interest in these materials is driven by their low density, lower even than that of aluminum alloys, and their excellent pressure die-casting capability, leading to manufacturing components with high geometric accuracy and structural homogeneity. Due to their biodegradability and biocompatibility, recent research has focused on using them in reconstructive surgery devices, similar to Zn-Mg alloys. As the blood circulatory system can, at certain stages, be considered similar to a hydraulic system, it is subjected to hydrodynamic flow regimes, including cavitation erosion. In this context, the current research, conducted on the AM50 magnesium-based alloy, provides new insights into its behavior and structural resistance exposed to shock waves and microjets generated by cavitation. Cavitation tests were performed using a standard 20 kHz vibratory device on three material conditions: one semi-finished (initial) state and two aged, heat-treated states at 200 °C for 12 and 24 h. Analyses of the characteristic erosion curves, cavitation resistance parameters, and macro- and microstructural examinations of the eroded surfaces revealed that, compared with the semi-finished condition, the applied heat-treatment regimes increased the HV5 hardness by 6.8–17% and the cavitation resistance by 27–61%.
The degradation of material surface structures caused by cavitation is of a mechanical nature due to cyclic local fatigue loading. Its intensity depends on both the material’s mechanical properties and its surface microstructure. Evaluating the surface structure resistance to cavitation loading can be performed based on experimentally determined mechanical properties and/or through macro- or microscopic analysis of the eroded structure. Manufacturers, designers, and users of hydromechanical equipment operating under cavitation conditions are interested in materials whose properties and structures can withstand cavitation loading. For this reason, the current experimental research in the field focuses on establishing relationships that express the influence of either mechanical properties or surface microstructure on the resistance of material structures to cavitation erosion. The current paper aligns with this research direction and aims to determine statistical relationships between mechanical properties and the cavitation erosion resistance of aluminum-based alloys. The mechanical properties considered include ultimate tensile strength (Rm), yield strength (Rp0.2), surface hardness (HB), resilience (KCU), and elongation at fracture (A5). Cavitation resistance is evaluated using the parameter Rcav, defined according to the ASTM G32-2016 standard. The experimental results were obtained from cavitation tests conducted using a standard vibratory device that complies with ASTM G32 requirements.
Aluminum is undoubtedly a key material in modern industry. Flat plates made of aluminum alloys are widely used in construction, aeronautics, automotive, and others. The current paper presents an analysis of the behavior of a thin plate made of Al7075-T651 aluminum alloy, subjected to a uniaxial stress, and clamped at one end. The results of the numerical simulation with FRANC2D software have been used for accurate determination of the stress intensity factors (KI, KII) and being validated for the simple cases using analytical calculations. The Failure Assessment Diagram (FAD) based on the toughness ratio Kr and the load ratio Lr has been used to evaluate the structural integrity of cracked components based on the load, its position, crack size, and the fracture properties of the material. The FAD analysis results highlight the significant influence of crack position on the values of the K factor. The edge and inclined cracks lead to increases in stress intensity factors and to the occurrence of mixed-mode loading conditions. The study demonstrates the effectiveness and usefulness of the proposed methodology in the analysis of structures with discontinuities and emphasizes the importance of crack positioning in assessing the safety of engineering components.