PANAGIOTA ANGELOPOULOU

Mrs. PANAGIOTA ANGELOPOULOU


Research Focus & Metrics

Academic Career Length

1Year (2026-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
8 October 2026 in Ceramics
Verified
Journal Article
Open access
PDF file
PAPANAGIOTA ANGELOPOULOU
PANAGIOTA ANGELOPOULOU
EREleni Roussi
Eleni Roussi
PGParaskevi Gkomoza
Paraskevi Gkomoza
MPMichaela Papageorgiou
Michaela Papageorgiou
OAOlga Alexiadou
Olga Alexiadou
IKIoanna Kitsou
Ioanna Kitsou
In this work, zirconia ceramic structures were fabricated by Direct Ink Writing (DIW) using water-based, yttria-stabilized nano-zirconia pastes. The pastes were prepared from 3 mol% yttria-stabilized zirconia nanopowders synthesized by sol–gel and co-precipitation routes. The effects of dispersant concentration and organic additives on paste preparation and printability were investigated, and the rheological behavior of the printable formulations was evaluated. The microstructure of the sintered 3D-printed specimens was examined by scanning electron microscopy (SEM), while apparent porosity, density, and compressive strength were determined. All printable pastes exhibited shear-thinning behavior. After sintering at 1500 °C, the printed specimens showed submicron grain sizes and apparent porosities as low as 3%. The formulation prepared without acrylamide and crosslinking agent (O12X) exhibited an apparent porosity of 3% and a compressive strength of 350 ± 25 MPa. The co-precipitated-powder formulation (2N) reached compressive-strength values of up to 360 ± 25 MPa. These results demonstrate the feasibility of using high-solids, water-based nano-zirconia pastes for DIW fabrication of dense zirconia structures and support further investigation of this approach for dental applications.