In this work, zirconia ceramic structures were fabricated by Direct Ink Writing (DIW) using water-based, yttria-stabilized nano-zirconia pastes. The pastes were prepared from 3 mol% yttria-stabilized zirconia nanopowders synthesized by sol–gel and co-precipitation routes. The effects of dispersant concentration and organic additives on paste preparation and printability were investigated, and the rheological behavior of the printable formulations was evaluated. The microstructure of the sintered 3D-printed specimens was examined by scanning electron microscopy (SEM), while apparent porosity, density, and compressive strength were determined. All printable pastes exhibited shear-thinning behavior. After sintering at 1500 °C, the printed specimens showed submicron grain sizes and apparent porosities as low as 3%. The formulation prepared without acrylamide and crosslinking agent (O12X) exhibited an apparent porosity of 3% and a compressive strength of 350 ± 25 MPa. The co-precipitated-powder formulation (2N) reached compressive-strength values of up to 360 ± 25 MPa. These results demonstrate the feasibility of using high-solids, water-based nano-zirconia pastes for DIW fabrication of dense zirconia structures and support further investigation of this approach for dental applications.
Hip joint surgeries, including total hip replacement or resurfacing, have increased tremendously in the last decades. Number of patients of all ages, replace their hip, due to severe injuries or trauma problems, so as to have a better life. According to these factors, new material and processes in implants manufacturing are imported to medicine, through research programs, every year. In the scope of one of these programs, that has to do with ceramic coatings on metallic resurfacing implants, a new 3axis Hip simulator was designed and manufactured in the Laboratory of Manufacturing Technology of the National Technical University of Athens. The scope of this paper is to present the main parts, materials and process used to manufacture the simulator as well as the way the simulator is working and how its movement in 3axis is accomplished. Furthermore, the evaluation of the machine and its use to examine resurfacing implants is presented.