In the last decades, vanadium alloyed coatings have been introduced as potential candidates for self-lubrication due to their perfect tribological properties. In this work, the influence of V incorporation on the wear performance and oxidation resistance of TiSiN/CrN film coatings deposited by direct current (DC) reactive magnetron sputtering is investigated. The results show that vanadium incorporation significantly decreases the oxidation resistance of the coatings. In general, two layers are formed during the oxidation process: i) Ti(V)O2 on top, followed by a protective layer, which is subdivided into two layers, Cr2O3 and Si-O. ii) The diffusion of V controls the oxidation of V-containing coatings. The addition of vanadium improves the wear resistance of coatings, and the wear rate decreases with increasing V content in the coatings; however, the friction coefficient is independent of the chemical composition of the coatings. The wear of the V-containing coatings is driven by polishing wear.
In this study, to further improve the performance of micro-arc oxidation (MAO) coatings, ZrO2 nanoparticles at different concentrations were added to the electrolyte. The effects of ZrO2 concentration on the microstructure, mechanical properties and corrosion resistance of the MAO composite coatings were systematically investigated. The coatings mainly consisted of α-Al2O3 and γ-Al2O3. The detection of ZrO2 confirmed the incorporation of the added particles. As the concentration increased from 0 to 6 g/L, the porosity decreased from 1.352% to 0.864%, whereas further addition increased the porosity. At 6 g/L, the mean microhardness reached 623 ± 50 HV0.05. Moreover, this coating showed the lowest friction coefficient of 0.135. In addition, its corrosion potential was −0.148 V, while its corrosion current density was 2.578 × 10−7 A·cm−2. It also exhibited the highest low-frequency impedance modulus. When the ZrO2 concentration was further increased, the coating porosity increased and the improvements gradually weakened. Overall, a suitable ZrO2 concentration promoted coating growth and reduced structural defects. It also improved the hardness, wear behavior and corrosion protection of the coating. Therefore, these findings provide a reference for the concentration design of ZrO2-modified MAO coatings. They also clarify the nonmonotonic relationship between coating growth, structural defects and performance.