Implantable devices need specific tailored surface morphologies and chemistries to interact with the living systems or to actively induce a biological response also by the release of drugs or proteins. These customised requirements foster technologies that can be implemented in additive manufacturing systems. Here we present a novel approach based on spraying processes that allows to control separately topographic features in the submicron range (∽ 60 nm - 2 µm), ammine or carboxylic chemistry and fluorophore release even on temperature sensitive biodegradable polymers such as polycaprolactone (PCL). We developed a two-steps process with a first deposition of 220 nm silica and poly(lactic-co-glycolide) (PLGA) fluorescent nanoparticles by aerosol followed by the deposition of a fixing layer by atmospheric pressure plasma jet (APPJ). The nanoparticles can be used to create the nano-roughness and to include active molecule release, while the capping layer ensures stability and the chemical functionalities. The process is enabled by a novel APPJ which allows deposition rates of 10 - 20 nm·s-1 at temperatures lower than 50 °C using argon as process gas. This approach was assessed on titanium alloys for dental implants and on PCL films. The surfaces were characterized by FT-IR, AFM and SEM. Titanium alloys were tested with pre-osteoblasts murine cells line, while PCL film with fibroblasts. Cell behaviour was evaluated by viability and adhesion assays, protein adsorption, cell proliferation, focal adhesion formation and SEM. The release of a fluorophore molecule was assessed in the cell growing media, simulating a drug release. Osteoblast adhesion on the plasma treated materials increased by 20% with respect to commercial titanium alloys implants. Fibroblast adhesion increased by a 100% compared to smooth PCL substrate. The release of the fluorophore by the dissolution of the PLGA nanoparticles was verified and the integrity of the encapsulated drug model confirmed.
Nowadays, nanophotonics aims towards low-cost chip-scale devices that can tailor electromagnetic properties, one of which is the control of circular polarization at the nanoscale. Here, we demonstrate the chiral properties of metasurfaces produced by means of nanosphere lithography combined with tilted metal deposition. We apply the photo-acoustic technique to characterize the circular dichroism (CD) at 633 nm of polystyrene nanospheres covered by three different metals: Au- and Cr-covered samples show extrinsic chiral behavior, while the Ag-covered sample shows CD at normal incidence, characteristic of intrinsic chirality. As the experimental data are in good agreement with numerical predictions, we believe that such design can be optimized to get efficient circularly polarized detection at the nanoscale.
The laser-induced plasmon heating of an ordered array of silver nanoparticles, under continuous illumination with an Ar laser, was probed by rare-earth fluorescence thermometry. The rise in temperature in the samples was monitored by measuring the temperature-sensitive photoluminescent emission of a europium complex (EuTTA) embedded in PMMA thin-films, deposited onto the nanoparticles array. A maximum temperature increase of 19 °C was determined upon resonant illumination with the surface plasmon resonance of the nanoarray at the highest pump Ar laser power (173 mW). The experimental results were supported by finite elements method electrodynamic simulations, which provided also information on the temporal dynamics of the heating process. This method proved to be a facile and accurate approach to probe the actual temperature increase due to photo-induced plasmon heating in plasmonic nanosystems.