Microcrystalline Cellulose (MCC) is an isolated, colloidal crystalline portion of cellulose fibers, and it is a valuable alternative to non-renewable fossil-based materials. It is used for a large plethora of different fields, such as composites, food applications, pharmaceutical and medical developments, and cosmetic and material industries. The interest of MCC has also been driven by its economic value. In the last decade, particular attention has been driven to the functionalization of its hydroxyl groups to expand the field of applications of such biopolymer. Herein, we report and describe several pre-treatment methods that have been developed to increase the accessibility of MCC by breaking its dense structure allowing further functionalization. This review also collects the results that have appeared in the literature during the last two decades on the utilization of functionalized MCC as adsorbents (dyes, heavy metals, and carbon dioxide), flame retardants, reinforcing agents, energetic materials, such as azide- and azidodeoxy-modified, and nitrate-based cellulose and biomedical applications.

Sodium‐ion batteries (SIBs) represent a potential alternative to lithium‐ion batteries in large‐scale energy storage applications. To improve the sustainability of SIBs, the utilization of anode carbonaceous materials produced from biomass and the selection of a bio‐based binder allowing an aqueous electrode processing are fundamental. Herein, corncobs are used as raw material for the preparation of hard carbon and it is also used as cellulose sources for the synthesis of carboxymethyl cellulose (CMC) binder. The corncob‐derived electrodes deliver a high discharge capacity of around 264 mAhg⁻¹ at 1 C (300 mAg⁻¹), with promising capacity retention (84 % after 100 cycles) and good rate capability. Additionally, this work expands the fundamental insight of the sodium storage behavior of Hard Carbons through an electrochemical approach, suggesting that the reaction mechanism is controlled by capacitive process in the sloping voltage region, while the diffusion‐controlled intercalation is the predominant process in the low‐voltage plateau.

Composite anode material based on Fe₃O₄ and reduced graphene oxide is prepared by base-catalysed co-precipitation and sonochemical dispersion. Structural and morphological characterizations demonstrate an effective and homogeneous embedding of Fe₃O₄ nanoparticles in the carbonaceous matrix. Electrochemical characterization highlights specific capacities higher than 1000 mAh g⁻¹ at 1C, while a capacity of 980 mAhg⁻¹ is retained at 4C, with outstanding cycling stability. These results demonstrate a synergistic effect by nanosize morphology of Fe₃O₄ and inter-particle conductivity of graphene nanosheets, which also contribute to enhancing the mechanical and cycling stability of the electrode. The outstanding capacity delivered at high rates suggests a possible application of the anode material for high-power systems.

In this work, the synthesis, characterization, and application of novel parabens imprinted polymers as highly selective solid-phase extraction (SPE) sorbents have been reported. The imprinted polymers were created using sol–gel molecular imprinting process. All the seven parabens were considered herein in order to check the phase selectivity. By means of a validated HPLC-photodiode array detector (PDA) method all seven parabens were resolved in a single chromatographic run of 25 min. These SPE sorbents, in-house packed in SPE empty cartridges, were first characterized in terms of extraction capability, breakthrough volume, retention volume, hold-up volume, number of theoretical plates, and retention factor. Finally, the device was applied to a real urine sample to check the method feasibility on a very complex matrix. The new paraben imprinted SPE sorbents, not yet present in the literature, potentially encourage the development of novel molecularly imprinted polymers (MIPs) to enhance the extraction efficiency, and consequently the overall analytical performances, when the trace quantification is required.