Ag semishells (AgSS) ordered arrays for surface-enhanced Raman scattering (SERS) spectroscopy have been prepared by depositing Ag film onto polystyrene colloidal particle (PSCP) monolayer templates array. The diversified activity for SERS activity with the ordered AgSS arrays mainly depends on the PSCP diameter and Ag film thickness. The high SERS sensitivity and reproducibility are proved by the detection of rhodamine 6G (R6G) and 4-aminothiophenol (4-ATP) molecules. The prominent enhancements of SERS are mainly from the “V”-shaped or “U”-shaped nanogaps on AgSS, which are experimentally and theoretically investigated. The higher SERS activity, stability and reproducibility make the ordered AgSS a promising choice for practical SERS low concentration detection applications.

Suppression of Fresnel reflection from diffraction grating surfaces is very important for many optical configurations. In this work, we propose a simple method to fabricate subwavelength structures on fused-silica transmission grating for optical antireflection. The fabrication is a one-step self-masking reaction ion etching (RIE) process without using any masks. According to effective medium theory, random cone-shaped nanopillars which are integrated on the grating surface can act as an antireflective layer. Effects of the nanostructures on the reflection and transmission properties of the grating were investigated through experiments and simulations. The nanostructure surface exhibited excellent antireflection performance, where the reflection of the grating surface was suppressed to zero over a wide range of incident angles. Results also revealed that the etching process can change the duty cycle of the grating, and thus the diffraction orders if there are oblique lateral walls. The simulation results were in good agreement with the experimental ones, which verified our physical comprehension and the corresponding numerical model. The proposed method would offer a low-cost and convenient way to improve the antireflective performance of transmission-diffractive elements.

α-Amino amides can be accessed directly form N-alkyl amines by the isocyanide-compatible oxidative copper-peroxide conditions even in the presence of water. Various functional groups are tolerated in the reaction, leading to the synthesis of various α-amino amides in moderate yield. A plausible mechanism is proposed in which an oxidative Ugi-type three-component pathway is supposed to be involved.

Femtosecond laser processing technology is an advanced sub-micro-processing technique that enables the non-contact processing of various materials. This technology can be used to apply sub-micro structures for purposes such as hydrophilicity enhancement, optical transmittance improvement, and photonics detection. However, when it comes to processing micro/nanostructures on highly brittle materials using femtosecond lasers, there are challenges such as low processing efficiency, generation of debris, and microcracking. In this paper, we propose a method called the out-of-focus femtosecond laser direct writing technique combined with wet etching. This method offers simplicity, speed, and flexibility in preparing dense, large-area sub-microstructured surfaces on the brittle material sapphire. Our detailed investigation focuses on the impact of laser processing parameters (direct writing period, distance of focusing, direct writing speed, etc.) on the sub-microstructures of Al₂O₃ surfaces. The results demonstrate that this method successfully creates embedded sub-microstructures on the sapphire surface. The microholes, with a diameter of approximately 2.0 μm, contain sub-micro structures with a minimum width of 250 ± 20 nm. Additionally, we conducted experiments to assess the optical transmittance of sapphire nanostructures in the range of 350–1200 nm, which exhibited an average transmittance of approximately 77.0%. The water contact angle (CA) test yielded a result of 52 ± 2°, indicating an enhancement in the hydrophilicity of the sapphire nanostructures with only a slight reduction in optical transmittance. Our efficient fabrication of sub-microstructures on the sapphire surface of highly brittle materials offers a promising method for the production and application of brittle materials in the field of micro-optics.