In this study, multilayer organic light-emitting diodes (OLEDs) consisting of three solution-processed layers are fabricated using slot die coating, gravure printing, and inkjet printing, techniques that are commonly used in the industry. Different technique combinations are investigated to successively deposit a hole injection layer (poly(3,4-ethylenedioxythiophene)-poly(styrenesulfonate) (PEDOT:PSS)), a cross-linkable hole transport layer (N,N′-bis(4-(6-((3-ethyloxetan-3-yl)methoxy)-hexyloxy)phenyl)-N,N′-bis(4-methoxyphenyl)biphenyl-4,4′-diamin (QUPD)), and a green emissive layer (TSG-M) on top of each other. In order to compare the application techniques, the ink formulations have to be adapted to the respective process requirements. First, the influence of the application technique on the layer homogeneity of the different materials is investigated. Large area thickness measurements of the layers based on imaging color reflectometry (ICR) are used to compare the application techniques regarding the layer homogeneity and reproducible film thickness. The total stack thickness of all solution-processed layers of 32 OLEDs could be reproduced homogeneously in a process window of 30 nm for the technique combination of slot die coating and inkjet printing. The best efficiency of 13.3 cd A−1 is reached for a process combination of slot die coating and gravure printing. In order to enable a statistically significant evaluation, in total, 96 OLEDs were analyzed and the corresponding 288 layers were measured successively to determine the influence of layer homogeneity on device performance.
12 December 2016 in Advanced Materials Technologies
Multilayer coatings and drying of polymer films are widely used to produce different applications like organic electronics or barrier foils. If the product quality requires separated layers, partial or immiscible systems can be used to avoid interdiffusion between the layers. For the prediction of a possible phase separation of a ternary polymer–polymer–solvent system, it is required to measure or obtain from a data bank the three binary interaction parameters of the system to describe its thermodynamic behavior. This poses a challenge due to the scarce data and measurement techniques for polymer–solvent interaction parameters, but even more for polymer–polymer interaction parameters. In this work, a numerical routine is developed to predict the phase separation for given interaction parameters and is validated with literature results. Subsequently, different ternary polystyrene–poly(methyl methacrylate)–toluene mixtures are prepared and the resulting composition of the phase (or phases) is measured via Raman spectroscopy. The determined equilibrium data are used to fit the binary interaction parameters, which can be used afterward as input parameters for the numerical routine in order to predict the ternary phase diagram of the system.