The use of thicker electrodes can contribute to a reduction in cell costs. However, the properties of the electrode must be kept in view to be able to meet the performance requirements. Herein, the possibility of simultaneous multilayer slot die coating is investigated to improve the electrode properties of medium‐ and high‐capacity anodes. The stable coating window of the two‐layer slot die coating process is investigated to produce property‐graded multilayer electrodes. Electrodes with different styrene–butadiene rubber (SBR) gradients are investigated with regard to adhesive force and electrochemical performance. An increase in the adhesive force of up to 43.5% and an increase in the discharge capacity is observed.
In this study, multilayer organic light-emitting diodes (OLEDs) consisting of three solution-processed layers are fabricated using slot die coating, gravure printing, and inkjet printing, techniques that are commonly used in the industry. Different technique combinations are investigated to successively deposit a hole injection layer (poly(3,4-ethylenedioxythiophene)-poly(styrenesulfonate) (PEDOT:PSS)), a cross-linkable hole transport layer (N,N′-bis(4-(6-((3-ethyloxetan-3-yl)methoxy)-hexyloxy)phenyl)-N,N′-bis(4-methoxyphenyl)biphenyl-4,4′-diamin (QUPD)), and a green emissive layer (TSG-M) on top of each other. In order to compare the application techniques, the ink formulations have to be adapted to the respective process requirements. First, the influence of the application technique on the layer homogeneity of the different materials is investigated. Large area thickness measurements of the layers based on imaging color reflectometry (ICR) are used to compare the application techniques regarding the layer homogeneity and reproducible film thickness. The total stack thickness of all solution-processed layers of 32 OLEDs could be reproduced homogeneously in a process window of 30 nm for the technique combination of slot die coating and inkjet printing. The best efficiency of 13.3 cd A−1 is reached for a process combination of slot die coating and gravure printing. In order to enable a statistically significant evaluation, in total, 96 OLEDs were analyzed and the corresponding 288 layers were measured successively to determine the influence of layer homogeneity on device performance.
In this work, a detailed study of the drying of battery electrodes of different thicknesses is presented. A mathematical model to calculate the solvent loading and film temperature over the drying time is experimentally validated. The model is based on a first study presenting a simulation model to predict the drying course when linear drying kinetics prevail and no resistance exists for solvent transport within the film. To shed some light on the drying behavior of electrode films with different thicknesses, the start of capillary pore emptying is observed using a digital microscope. In the experiments, an onset of capillary transport even before the end of film shrinkage is observed for the electrode films with thicknesses above state‐of‐the‐art‐thickness. A clusterwise drying behavior becomes more distinct for thicker electrodes, with large areas of dry and wet capillaries next to each other, compared to a more homogenous drying of the thin electrodes. Based on these findings, the linear model is extended to consider transport limitations within the porous electrode film in the form of a moving drying front. The experiments show an increasing deviation from the linear model with increasing electrode thickness and the extended simulation, which considers transport resistances within the film, shows good agreement.
12 December 2016 in Advanced Materials Technologies