Chalcogenide phase change materials based on germanium-antimony-tellurides (GST-PCMs) have shown outstanding properties in non-volatile memory (NVM) technologies due to their high write and read speeds, reversible phase transition, high degree of scalability, low power consumption, good data retention, and multi-level storage capability. However, GST-based PCMs have shown recent promise in other domains, such as in spatial light modulation, beam steering, and neuromorphic computing. This paper reviews the progress in GST-based PCMs and methods for improving the performance within the context of new applications that have come to light in recent years.
We experimentally demonstrate a thermally induced reflective optical limiter using Ge 2 Sb 2 Te 5 (GST) and SiO 2 in a multilayer photonic bandgap edge-filter configuration. In the PASS state, greater than 80% transmission was achieved at λ ~ 1500 nm over a 300 nm spectral bandwidth and ±45° angles of incidence. In the BLOCK state, extinction ratios higher than 30 dB were achieved. By comparison, all previous optical limiters based on nonlinear photonic crystals have severe spectral bandwidth and/or angle of incidence limitations in either the PASS or BLOCK states. A nine-layer implementation of this device was fabricated and tested in this paper. Numerical modeling results show reasonable agreement with measured values. To the best of our knowledge, this is the first demonstration of optical limiting over a broad spectral band using phase change materials with this level of performance. However, it should be noted that although GST can be switched in both directions, the experimental results demonstrated in this paper are limited to PASS-to-BLOCK switching only.
The large impedance mismatch between the highly resistive amorphous state and the highly conductive crystalline state of is an impediment for the realization of high-speed electrically switched optical devices. In this paper, we demonstrate that tungsten doping can reduce this resistivity contrast and also results in a lower amorphous state resistivity. Additionally, it lowers the contact resistance, improves the optical contrast, and extends the face-centered-cubic state up to , with a minimal impact on thermal conductivity.
In this paper we show that the internal quantum efficiency of NiSi Schottky-barrier photodetectors can be significantly improved as the silicide film thickness is reduced close to its percolation threshold. We fabricated photodetectors in two optical configurations (front-side and back-side illuminated) at four different film thicknesses between 1-4 nm as well as a thick (100 nm) reference device. We simultaneously fit the reflection and transmission data for each silicide film on silicon as well as for front and backside illuminations to extract the refractive index dispersion of each film. Using this technique, we can accurately determine the absorption of each constituent layer and extract the wavelength-dependent internal quantum efficiency from the external quantum efficiency. We show that the internal quantum efficiency is highly dependent on the silicide film thickness while the dark current is not. The internal quantum efficiency of our thinnest detector is the highest reported of any silicide Schottky-barrier photodetector of comparable barrier height to date with a 57× improvement over the thick (reference) device. Using an approximation to Vickers' model, we were able to fit the IQE spectra to extract the hot carrier mean-free path of electrons in NiSi.
We describe a new fabrication method for making wire-grid polarizers for the visible and near-IR based on deep-UV interference lithography, nanoimprint, and glancing angle deposition. We fabricated aluminum wire grids with periods ranging from 375 to 230 nm with heights from 145 to 110 nm, respectively. The measured extinction ratio was as high as 220:1 at 1064 nm. The performance of the polarizer is limited by the roughness and porosity of the Al film and the underlying SU-8 structure. This method allows patterning of wire grids on any substrate material, which makes this an attractive method for fabricating wire-grid micropolarizers in a timely and cost-effective manner.