The problem of fault diagnosis (FD) and fault tolerant control (FTC) for a class of Takagi-Sugeno (T-S) fuzzy stochastic distribution control (SDC) systems subject to sensor and actuator faults is discussed in this paper. First, fuzzy logic models are used to approximate the output probability density function (PDF). Next, an adaptive augmented state/fault diagnosis observer is proposed to estimate the system state, sensor and the actuator faults simultaneously. New expected weights based on the sensor fault estimation information and a PI-type fuzzy feedback fault tolerant (FT) controller are designed to compensate the effect of sensor fault and actuator fault simultaneously. When the sensor fault occurs, the expected objective is redesigned to compensate the sensor fault. Meanwhile, the PI controller can compensate the effect of actuator fault, and the output PDF of the system can still track the desired PDF after the fault occurs. Finally, an example of quality distribution control in chemical reaction process is given to confirm the effectiveness of the algorithm.

A fault isolation, estimation, and fault-tolerant control (FTC) scheme for nonlinear time-varying delay stochastic distribution control systems was presented in this paper. The Takagi-Sugeno fuzzy model was adopted to approach the nonlinear dynamics of time-varying delay systems. According to the output equivalence principle and Laplace transformation, an augmented state vector was given to solve the time-varying delay problem. When multiple actuator faults and interference occur simultaneously, fault detection, isolation and fault estimation was designed to obtained the fault information. To decouple faults and obtain the value and location information of the fault, the system was separated into two parts through the designed multiple conversion matrices, in which one subsystem was only affected by one actuator fault. This has simplified the design of fault isolation and estimation. A adaptive observer for fault estimation was given. Then, fault information such as the time, location, and size was determined. The observer gain matrices were calculated using linear matrix inequality (LMI). When a fault was detected and diagnosed, a FTC algorithm was devised using the proportional-integral control scheme to compensate the fault as much as possible. It has been shown that even if multiple faults actuator occurred simultaneously, the FTC controller still ensured the output probability density function of the system traced the desired probability density function when a fault occurred. Finally, the expected results were obtained through the simulation example, which confirmed the effectiveness of the method.

In this article, a fault-tolerant tracking control strategy is investigated for nonlinear probability density function (PDF) control systems with the actuator fault, uncertainties, unknown disturbance, and random packet losses. The control input signal dropout and measurement signal dropouts are described as the independent Bernoulli distribution. An adaptive fault diagnosis (FD) observer based on the Lyapunov function is given to simultaneously estimate the fault, disturbance, and state with packet losses. Different from the traditional robust fault-tolerant control (FTC), a new active fault-tolerant tracking controller is designed based on the model predictive control framework, which has better adaptive fault-tolerant performance. Finally, the validity of the proposed FTC method has been proved by a simulation study of a papermaking process.

The fault diagnosis (FD) and fault tolerant control (FTC) problem of the fuzzy stochastic distribution system (SDS) over packet dropout and time delay is studied. Firstly, the static model of linear fuzzy logic system that approximates the output PDF and the dynamic model with the multiplicative fault in a fuzzy system are established. The random packet dropout and time delay caused by the network are described in a unified framework, in which the lost data is compensated with the latest data received by the buffer. On this basis, an adaptive observer is devised to estimate the unknown multiplicative fault. The design of sliding mode predictive fault tolerant controller is discussed to ensure that the system still has good tracking performance after the fault occurs. Numerical simulations on a molecular weight distribution control system are supplied to prove the effectiveness of the presented scheme. Note to Practitioners —The motivation of this paper is to improve the reliability of the fuzzy stochastic distribution system with packet dropout and time delay. This kind of stochastic distribution systems is described by the relationship between the input and the output PDF rather than the normal relationship between the input and the output. When the multiplicative fault occurs in the system, the design of fault diagnosis strategy and fault-tolerant controller becomes an important challenge, especially when the system is subject to packet dropout and time delay. To address the above problems, a new fault diagnosis and fault-tolerant control scheme is proposed, which can accurately estimate the time and size of the fault and obtain the satisfactory fault-tolerant control effect.

The purpose of the fault detection and diagnosis of stochastic distribution control systems is to use the measured input and the system output probability density functions (PDFs) to obtain the fault information of the system. In this paper, the rational square‐root B‐spline model is used to represent the dynamics between the output PDF and the input. This is then followed by the novel design of a non‐linear neural network observer‐based fault diagnosis (FD) algorithm so as to diagnose the fault in the dynamic part of such systems. Convergency analysis is performed for the error dynamic system raised from the fault detection and diagnosis phase using the Lyapunov stability theorem. Finally, based on the FD information, a new fault‐tolerant control based on proportional integral tracking control scheme is designed to make the post‐fault PDF still track the given distribution. A simulated example is given to illustrate the efficiency of the proposed algorithms.