Yunfeng Kang

Yunfeng Kang

Auto-generated profile, based on publicly available information

Yunfeng Kang

School of Electrical and Information Engineering, Zhengzhou University, Zhengzhou, China

Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
18 September 2020 in IEEE Transactions on Fuzzy Systems
Verified
Journal Article
Closed access
HWHao Wang
Hao Wang
YKYunfeng Kang
Yunfeng Kang
LYLina Yao
Lina Yao
Hong WangHong Wang
Hong Wang
Zhiwei GaoZhiwei Gao
Zhiwei Gao
The problem of fault diagnosis (FD) and fault tolerant control (FTC) for a class of Takagi-Sugeno (T-S) fuzzy stochastic distribution control (SDC) systems subject to sensor and actuator faults is discussed in this paper. First, fuzzy logic models are used to approximate the output probability density function (PDF). Next, an adaptive augmented state/fault diagnosis observer is proposed to estimate the system state, sensor and the actuator faults simultaneously. New expected weights based on the sensor fault estimation information and a PI-type fuzzy feedback fault tolerant (FT) controller are designed to compensate the effect of sensor fault and actuator fault simultaneously. When the sensor fault occurs, the expected objective is redesigned to compensate the sensor fault. Meanwhile, the PI controller can compensate the effect of actuator fault, and the output PDF of the system can still track the desired PDF after the fault occurs. Finally, an example of quality distribution control in chemical reaction process is given to confirm the effectiveness of the algorithm.

21 January 2021 in IEEE Transactions on Fuzzy Systems
Verified
Journal Article
Closed access
YKYunfeng Kang
Yunfeng Kang
LYLina Yao
Lina Yao
Hong WangHong Wang
Hong Wang
A fault isolation, estimation, and fault-tolerant control (FTC) scheme for nonlinear time-varying delay stochastic distribution control systems was presented in this paper. The Takagi-Sugeno fuzzy model was adopted to approach the nonlinear dynamics of time-varying delay systems. According to the output equivalence principle and Laplace transformation, an augmented state vector was given to solve the time-varying delay problem. When multiple actuator faults and interference occur simultaneously, fault detection, isolation and fault estimation was designed to obtained the fault information. To decouple faults and obtain the value and location information of the fault, the system was separated into two parts through the designed multiple conversion matrices, in which one subsystem was only affected by one actuator fault. This has simplified the design of fault isolation and estimation. A adaptive observer for fault estimation was given. Then, fault information such as the time, location, and size was determined. The observer gain matrices were calculated using linear matrix inequality (LMI). When a fault was detected and diagnosed, a FTC algorithm was devised using the proportional-integral control scheme to compensate the fault as much as possible. It has been shown that even if multiple faults actuator occurred simultaneously, the FTC controller still ensured the output probability density function of the system traced the desired probability density function when a fault occurred. Finally, the expected results were obtained through the simulation example, which confirmed the effectiveness of the method.



17 September 2024 in IEEE Transactions on Instrumentation and Measurement
Verified
Journal Article
Closed access
YKYunfeng Kang
Yunfeng Kang
LYLina Yao
Lina Yao
In this paper, a fault diagnosis scheme is proposed for permanent magnet synchronous motor (PMSM) system with multiple faults scenario. A novel diagnostic framework is designed to specifically address the challenge of the coupled demagnetization and speed sensor fault. Firstly, to decouple the mutual influence of the demagnetization fault and the speed sensor fault and reduce computational complexity, a novel super-twisting sliding mode observer (STSMO) is designed. It estimates the counter electromotive force (CEMF) along the αβ-axis with high precision, and then the estimated value is used to recalculate the motor speed, effectively alleviating the cross-impact of multiple faults. Then a novel sliding mode function is introduced, and an enhanced sliding mode observer (SMO) is designed based on this function. So that the demagnetization fault and the external perturbation can be estimated simultaneously. Then, a comprehensive system stability analysis is then conducted to verify the convergence of the proposed scheme. Finally, the proposed algorithm is rigorously tested through extensive simulations and experiments. It is demonstrated that the algorithm provides accurate and reliable diagnosis of both the demagnetization fault and the speed sensor fault under different fault severities.

22 February 2024 in IEEE Transactions on Instrumentation and Measurement
Verified
Journal Article
Closed access
YKYunfeng Kang
Yunfeng Kang
LYLina Yao
Lina Yao
A fault isolation and estimation scheme for turn-to-turn short circuit (TTSC) in the permanent magnet synchronous motor (PMSM) systems is proposed in this paper. When the short circuit fault occurs, the fault phase current will change, while to simplify the calculation difficulty, the short-circuit fault is modelled as current change in the two-phase rotating coordinate system. Then a fault detection observer is designed to detect the fault occurrence time, then the coordinate transformation technique is developed to convert the system into subsystems affected only by single fault. Adaptive observers are designed to estimate the fault and disturbance simultaneously. The observer parameters are determined by linear matrix inequality. The specific location of the short-circuit fault can be known after the inverse Park transformation. Finally, experimental results and comparison experimental results provide evidence of the feasibility of the suggested algorithm.