In this paper, four composite coatings of nano-SnS/polyvinylbutyral (PVB), nano-MoS2/PVB, nano-SnS-Zn/PVB, and nano-MoS2-Zn/PVB were prepared, and their anti-corrosion mechanism was analyzed by experimental and theoretical calculations. The results of the electrochemical experiments show that the effect of nano-MoS2 on the corrosion protection performance of PVB coating is better than that of nano-SnS in 3% NaCl solution, and that the addition of Zn further enhances this effect, which is consistent with the results of weight loss measurements. Furthermore, the observation of the corrosion matrix by the field emission scanning electron microscope (FESEM) further confirmed the above conclusion. At last, the molecular dynamics (MD) simulation were carried out to investigate the anti-corrosion mechanism of the nanofillers/PVB composites for the copper surface. The results show that both nano-SnS and nano-MoS2 are adsorbed strongly on the copper surface, and the binding energy of nano-MoS2 is larger than that of nano-SnS.
23 July 2019 in Physical Chemistry Chemical Physics
P-Type semiconductor SnS-based composite coatings can efficiently enhance the inhibited corrosion-promotion activity and improve the anti-corrosion performance for ocean engineering.
26 May 2021 in Acta Crystallographica Section C Structural Chemistry
In this paper, a innovative three dimensional anode-supported Solid Oxide Fuel Cell (SOFC) model with pressure equalization slots is developed by Computational Fluid Dynamics (CFD) methods. The pressure equalization applied in microreactor is introduced to SOFC flow field design optimization. The comparison between traditional parallel gas channel design and advanced design is finished, including the flow uniformity and cell performance parameters. Finally, the optimized SOFC model with pressure equalization slots has stronger performance than traditional planar SOFC model with parallel gas channels, which is able to be used as the future SOFC model design and optimization.
The sensing effect of P doped gallium sulfide on different gas molecules is studied by the first principle. And Ea, d, ΔQ, DOS, PDOS and ELF are calculated to research the sensing performance of the sheet. Finally, it is found that the P-GaS substrate has a good sensing performance for NH3 with the appropriate Ea (-0.40 eV) and ΔQ (0.22 e). The most important thing is that there is a strong physical adsorption between them. And there is no chemical bond between the doped substrate and the gas molecule, which provided the possibility of desorption. This shows that the P-GaS has high sensitivity and selectivity to NH3, therefore, it has the potential as a material for NH3.