In this paper, four composite coatings of nano-SnS/polyvinylbutyral (PVB), nano-MoS2/PVB, nano-SnS-Zn/PVB, and nano-MoS2-Zn/PVB were prepared, and their anti-corrosion mechanism was analyzed by experimental and theoretical calculations. The results of the electrochemical experiments show that the effect of nano-MoS2 on the corrosion protection performance of PVB coating is better than that of nano-SnS in 3% NaCl solution, and that the addition of Zn further enhances this effect, which is consistent with the results of weight loss measurements. Furthermore, the observation of the corrosion matrix by the field emission scanning electron microscope (FESEM) further confirmed the above conclusion. At last, the molecular dynamics (MD) simulation were carried out to investigate the anti-corrosion mechanism of the nanofillers/PVB composites for the copper surface. The results show that both nano-SnS and nano-MoS2 are adsorbed strongly on the copper surface, and the binding energy of nano-MoS2 is larger than that of nano-SnS.
The co-combustion of dry coal and sludge was carried out in a self-built laboratory scale fluidized bed furnace. We used FTIR spectroscopy, high-resolution gas chromatography, high-resolution mass spectrometry, and XRF to capture and dynamically observe the flue gas fly ash and bottom ash. The sludge sample was taken from a municipal sewage treatment plant and its mixing ratio was below 20%. The temperature distribution of the furnace was observed and the emissions of the main gaseous pollutants such as SO2, NOx, and dioxins were measured in the combustion process. The heavy metal contents of fly ash and bottom ash were later detected to analyze the migration characteristics. The results showed that all of the gaseous pollutants measured increased linearly with the sludge mixing ratio. However, it could also meet the 1 metal content of bottom ash and fly ash did not change much. Through the elaboration of the above points, this study can provide guidance for future research on the co-combustion of coal boiler sludge and suggest favorable conditions for the co-combustion of coal boiler sludge.
23 July 2019 in Physical Chemistry Chemical Physics
P-Type semiconductor SnS-based composite coatings can efficiently enhance the inhibited corrosion-promotion activity and improve the anti-corrosion performance for ocean engineering.
1 November 2020 in IOP Conference Series: Earth and Environmental Science
Waste incineration power generation is a main method of waste disposal, and high temperature corrosion has always been a key issue restricting the development of this technology. This paper reviews the research progress of high temperature corrosion mechanism of waste incineration boilers. Based on the chemical reaction of high temperature corrosion of chloride, the mechanism of chloride corrosion of boiler metal fittings is discussed. The analysis results show that the high-temperature flue gas corrosion mainly includes HCl gas corrosion, molten salt corrosion and sulfide corrosion. In addition, the analysis of the high-temperature soot corrosion mechanism shows that the corrosion behavior of the heated surface in the presence of sintered ash is stress cracking corrosion. This is the result of the combined effect of the stress destruction of dense sintered ash and the ion diffusion corrosion reaction of chlorine in the ash.
20 May 2020 in Physical Chemistry Chemical Physics
Correction for ‘Liquid-phase exfoliated SnS as a semiconductor coating filler to enhance corrosion protection performance’ by Hongyu Tang et al., Phys. Chem. Chem. Phys., 2019, 21, 18179–18187, DOI: 10.1039/C9CP03381E.