In the present paper, Graphene Oxide (GO) particles were prepared via Hummer method, and used in synthesis of composite membranes. Polyethersulfone (PES) nanocomposite membranes were synthesized via wet phase inversion technique, and using water as non-solvent. The membrane morphology was investigated using scanning electron microscopy (SEM). Change in the membrane surface hydrophilicity after modification was studied using contact angle measurements. The performance of fabricated PES nanocomposite membranes was measured by evaluating pure water flux, salt rejection, dye retention and heavy metals removal. The results indicated that by increasing the filler percentage up to 5 wt.%, the contact angle between the water droplet and the membrane surface was decreased and the droplet was more dispersed on the membrane surface which implies higher hydrophilicity of the prepared nanocomposite membranes. Moreover, the experimental results corroborated that addition of GO to the membrane significantly improved the pure water flux, salt rejection and heavy metals removal, and can be used as a novel methodology for preparation of high performance membranes in water treatment.
The design and development of an environmentally benign porous adsorbent for effective simultaneous adsorption of organic dyes and heavy metals from water are important but remain a big challenge. Herein, we have designed a layered double hydroxide/metal–organic framework-based hierarchical nanocomposite (LDH/MOF HNC) by a facile, room-temperature in situ approach. This paper for the first time reports a hierarchical trimodal micro-meso-macroporous LDH/MOF composite with a high surface area (surface area 1282 m2 g−1 and pore volume 0.93 cm3 g−1), synthesised by uniformly growing MOF nanocrystals on the surface of LDH nanosheet ultrathin films. An attempt is made to quantitatively demonstrate the adsorption data via suitable nonlinear kinetic and isotherm equations for single, simultaneous, and consecutive adsorption of the orange II reactive dye and Cr(VI). Experiments were performed at various values of pH (6.0–11.0), adsorbent dosages (1.0–8.0 mg), adsorbate concentrations (5–500 mg L−1), and temperatures (293–323 K). The Langmuir model revealed a satisfactory fit to the equilibrium data of the LDH/MOF HNC (correlation coefficients R2 > 0.98) with a calculated maximum adsorption capacity of 1173 and 733 mg g−1 for orange II and Cr(VI), respectively, in a simultaneous adsorption system. The results of the study demonstrated that LDH/MOF HNCs could potentially be applied as a promising nanoadsorbent for the simultaneous removal and extraction of toxic dyes and metals from water.
The influence of lignin modification on drug release and pH-dependent releasing behavior of oral solid dosage forms was investigated using three different formulations. The first formulation contains microcrystalline cellulose (MCC 101) as the excipient and paracetamol as the active pharmaceutical ingredient (API). The second formulation includes Alcell lignin and MCC 101 as the excipient and paracetamol, and the third formulation consists of carboxylated Alcell lignin, MCC 101 and paracetamol. Direct compaction was carried out in order to prepare the tablets. Lignin can be readily chemically modified due to the existence of different functional groups in its structure. The focus of this investigation is on lignin carboxylation and its influence on paracetamol control release behavior at varying pH. Results suggest that carboxylated lignin tablets had the highest drug release, which is linked to their faster disintegration and lower tablet hardness.