The illumination optical system using a laser diode has advantages such as small size and high efficiency compared to an optical system using a conventional light source. In particular, its advantages can be maximized in high-resolution spatial light modulation. Based on these advantages, research to apply laser diode scanning to high-resolution adaptive driving beam (ADB) is currently being actively conducted. To construct a high-resolution illumination optical system for an ADB system using a single laser diode as a light source, the configuration of an optical scanning system is essential. In the general high-speed scanning method, the optical power at the center is relatively smaller compared with that at the edge because of the faster scanning speed when the center is illuminated. This causes large losses in automotive lighting optical system where the optical power in the center should be higher. Herein, we propose an optical system that can change the light power distribution of the center and the edge by applying a prism. In addition, by producing a prototype of an optical scanning system, the effect of efficiently distributing optical power by the designed optical scanning system was experimentally verified.

The applicability of a polyether ether ketone locking compression plate (PEEK LCP) fabricated using FDM (fused deposition modeling)-based 3D printing to treat actual patients was studied. Three different tests—bending, axial compression, and axial torsion—were conducted on tibial non-osteoporotic comminuted diaphyseal fracture samples fixed with the commercial titanium alloy LCP and 3D-printed PEEK LCP. Comparing the outcomes of these tests revealed that the commercial titanium alloy LCP underwent plastic deformation in the bending and axial torsion tests, though the LCP did not fail even when an external force greater than the maximum allowable load of the tibia fixture of the LCP was applied. Elastic deformation occurred in the 3D-printed PEEK LCP in the bending and axial torsion tests. However, deformation occurred even under a small external force, and its stiffness was 10% compared to commercial titanium alloy LCP. Thus, 3D-printed PEEK LCP can be applied to the fracture conditions in non-weight-bearing regions. The experimental results reveal detailed insights into the treatment of actual patients by considering the stiffness and high toughness of 3D-printed PEEK LCP.