Solution-based direct patterning on an elastomer substrate with meniscus-dragging deposition (MDD) enables fabrication of very thin carbon nanotube (CNT) layers in the nanometer scale (80–330 nm). To fabricate the CNT pattern with CNT solution, contact angle, electrical variation, mechanical stress, and surface cracks of elastomer substrate were analyzed to identify the optimal conditions of O2 treatment (treatment for 30 s with RF power of 50 W in O2 atmosphere of 50 sccm) and mixture ratio between Ecoflex and polydimethylsiloxane (PDMS) (Ecoflex:PDMS = 5:1). The type of mask for patterning of the CNT layer was determined through quantitative analysis for sharpness and uniformity of the fabricated CNT pattern. Through these optimization processes, the CNT pattern was produced on the elastomer substrate with selected mask (30 μm thick oriented polypropylene). The thickness of CNT pattern was also controlled to have hundreds nanometer and 500 μm wide rectangular and circular shapes were demonstrated. Furthermore, the change in the current and resistance of the CNT layer according to the applied strain on the elastomer substrate was analyzed. Our results demonstrated the potential of the MDD method for direct CNT patterning with high uniformity and the possibility to fabricate a stretchable sensor.
1 October 2015 in Journal of the Korean Physical Society
A DC voltage-dependent color-tunable organic light-emitting diode (CTOLED) was proposed for lighting applications. The CTOLED consists of six consecutive organic layers: the hole injection layer, the hole transport layer (HTL), two emission layers (EMLs), a hole blocking layer (HBL), and an electron transport layer (ETL). Only one metal-free phthalocyanine (H2Pc) layer with a thickness of 5 nm was employed as the EML in the CTOLED on a green organic light-emitting diode (OLED) structure using tris (8-hydroxyquinoline) aluminum (III) (Alq3). The current density-voltage-luminance characteristics of the CTOLEDs before and after thermal treatment were characterized and analyzed. Several Gaussian peaks were also extracted by multipeak fitting analysis of the electroluminescent spectra. In the CTOLED before thermal treatment, green emission was dominant in the entire voltage range from low to high voltages, and blue and infrared were emitted simultaneously and at relatively low intensities at low and high voltages, respectively. In the CTOLED after thermal treatment, the dominant color conversion from blue to green was observed as the applied voltage increased, and the infrared emission was relatively low over the entire voltage range. By simulating the CTOLED with and without traps at the H2Pc interface using a technology computer-aided design simulator, we observed the following: 1. After thermal treatment, the CTOLED emitted blue light by exciton generation at the H2Pc–HBL interface because of the small electron transport through the H2Pc thin film due to the dramatic reduction of traps in the low-voltage regime. 2. In the high-voltage regime, electrons reaching the HBL were transferred to Alq3 by resonant tunneling in two quantum wells; thus, green light was emitted by exciton generation at the HTL–Alq3 interface.
31 July 2025 in Journal of Sensor Science and Technology