The high metabolic flexibility and biodiversity of microalgae make them promising systems for the production of chemicals and high-value metabolites to be utilized in various industrial applications. Currently, microalgae are primarily cultivated in phototrophic processes or in fermenters using glucose as substrate. However, such configurations are often too costly for the majority of potential applications and require improvements. The use of acetate as substrate to enhance biomass productivity and reduce cost and environmental impacts is a promising solution. In a future bio-based economy, acetate can serve as an excellent intermediate to link many industrial facilities, as it can be synthesized using different technologies from renewable resources as CO₂ and waste. This work provides a detailed description of acetate synthesis processes alternative to the conventional methanol carbonylation, including the pros and cons of each: aerobic and anaerobic fermentations; thermochemical treatments; C1 gas fermentation; microbial electrosynthesis and artificial photosynthesis. Additionally, the utilization of acetate as substrate for microalgae growth in mixotrophic and heterotrophic conditions is reviewed, covering key metabolic and engineering aspects (strains, yields, growth rate, inhibition, productivity, process configuration). These aspects serve as guidelines for a rationale design of an algal cultivation process based on acetate as a carbon source. Finally, the review critically assesses the state of the art of coupling of acetate-rich streams with algal biomass production, highlighting the pros and cons and addressing the main knowledge gaps to be filled through future research.

In recent years, great attention has been focused on rapid, selective, and environmentally friendly extraction methods to recover pigments and antioxidants from microalgae. Among these, supercritical fluid extraction (SFE) represents one of the most important alternatives to traditional extraction methods carried out with the use of organic solvents. In this study, the influence of parameters such as pressure, temperature, and the addition of a polar co-solvent in the SFE yields of carotenoids and fat-soluble vitamins from T. obliquus biomass were evaluated. The highest extraction of alpha-tocopherol, gamma-tocopherol, and retinol was achieved at a pressure of 30 MPa and a temperature of 40 °C. It was observed that overall, the extraction yield increased considerably when a preliminary step of sample pre-treatment, based on a matrix solid phase dispersion, was applied using diatomaceous earth as a dispersing agent. The use of ethanol as a co-solvent, under certain conditions of pressure and temperature, resulted in selectively increasing the yields of only some compounds. In particular, a remarkable selectivity was observed if the extraction was carried out in the presence of ethanol at 10 MPa and 40 °C: under these conditions, it was possible to isolate menaquinone-7, a homologous of vitamin K2, which, otherwise, cannot not recovered by using traditional extraction procedures.