A wideband circularly polarized (CP) substrate integrated waveguide (SIW) cavity-backed stacked dipoles array antenna is proposed for millimeter-wave (mm-wave) applications. Firstly, double-layer SIW cavities are utilized to construct the CP stacked dipole element, which consists of two crossed stacked linearly polarized (LP) electric dipoles and four metallic probes in driven, short-circuited, and suspended states. These probes can achieve orthogonal phase and energy coupling through a magnetic field without additional baluns. Next, wideband CP working principle and parameter analysis of the element are addressed. A full corporate feeding scheme with 4-way SIW power divider and 4 SIW cavities is adopted for array verification. Finally, a 4 × 4 array is designed, fabricated, and measured, which demonstrates wide impedance bandwidth of 28.1%, wide axial ratio (AR) bandwidth of 23%, and a peak gain of 19.35 dBic, respectively. These results demonstrate that the CP stacked dipole is a promising candidate for mm-wave wireless systems.
Due to the dense deployment of base stations (BSs) in heterogeneous cellular networks (HCNs), the energy efficiency (EE) of HCN has attracted the attention of academia and industry. Considering its mathematical tractability, the Poisson point process (PPP) has been employed to model HCNs and analyze their performance widely. The PPP falls short in modeling the effect of interference management techniques, which typically introduces some form of spatial mutual exclusion among BSs. In PPP, all the nodes are independent from each other. As such, PPP may not be suitable to model networks with interference management techniques, where there exists repulsion among the nodes. Considering this, we adopt the Matérn hard-core process (MHCP) instead of PPP, in which no two nodes can be closer than a repulsion radius from one another. In this paper, we study the coverage performance and EE of a two-tier HCN modelled by Matérn hard-core process (MHCP); we abbreviate this kind of two-tier HCN as MHCP-MHCP. We first derive the approximate expression of coverage probability of MHCP-MHCP by extending the approximate signal to interference ratio analysis based on the PPP (ASAPPP) method to multi-tier HCN. The concrete SIR gain of the MHCP model relative to the PPP model is derived through simulation and data fitting. On the basis of coverage analysis, we derive and formulate the EE of MHCP-MHCP network. Simulation results verify the correctness of our theoretical analysis and show the performance difference between the MHCP-MHCP and PPP modelled network.
Heterogeneous cellular networks (HCNs) have emerged as the primary solution for explosive data traffic. However, an increase in the number of base stations (BSs) inevitably leads to an increase in energy consumption. Energy efficiency (EE) has become a focal point in HCNs. In this paper, we apply tools from stochastic geometry to investigate and optimize the energy efficiency (EE) for a two-tier HCN. The average achievable transmission rate and the total power consumption of all the BSs in a two-tier HCN is derived, and then the EE is formulated. In order to maximize EE, a one-dimensional optimization algorithm is used to optimize picocell BS density and transmit power. Based on this, an alternating optimization method aimed at maximizing EE is proposed to jointly optimize transmit power and density of picocell BSs. Simulation results validate the accuracy of the theoretical analysis and demonstrate that the proposed joint optimization method can obviously improve EE.
Target detection helps to identify, locate, and monitor key components and potential issues in power sensing networks. The fusion of infrared and visible light images can effectively integrate the target the indication characteristics of infrared images and the rich scene detail information of visible light images, thereby enhancing the ability for target detection in power equipment in complex environments. In order to improve the registration accuracy and feature extraction stability of traditional registration algorithms for infrared and visible light images, an image registration method based on an improved SIFT algorithm is proposed. The image is preprocessed to a certain extent, using edge detection algorithms and corner detection algorithms to extract relatively stable feature points, and the feature vectors with excessive gradient values in the normalized visible light image are truncated and normalized again to eliminate the influence of nonlinear lighting. To address the issue of insufficient deep information extraction during image fusion using a single deep learning network, a dual ResNet network is designed to extract deep level feature information from infrared and visible light images, improving the similarity of the fused images. The image fusion technology based on the dual ResNet network was applied to the target detection of sensing insulators in the power sensing network, improving the average accuracy of target detection. The experimental results show that the improved registration algorithm has increased the registration accuracy of each group of images by more than 1%, the structural similarity of image fusion in the dual ResNet network has been improved by about 0.2% compared to in the single ResNet network, and the mean Average Precision (mAP) of the fusion image obtained via the dual ResNet network has been improved by 3% and 6% compared to the infrared and visible light images, respectively.
Two‐way amplify‐and‐forward (AF) relaying networks have been widely studied because of their simplicity and high spectral efficiency characteristics. Power allocation (PA) and relay selection (RS) for two‐way AF relaying systems are of particular interest. However, most of the previous studies only consider the PA and RS for these systems with symmetric traffic requirements. In this study, the authors’ focus on the minimum transmit power (MTP) under/considering RS for asymmetric two‐way relaying networks. The authors’ derive the MTP required for two‐way AF relaying transmission with asymmetric traffic requirements, and propose an optimal RS criterion based on the derived MTP. First, the outage probability (OP) of two‐way relaying transmission based on statistical channel state information (CSI) is derived. Then, by converting a geometric programming to a convex optimisation problem, the closed‐form solution of the PA aiming at minimising total transmit power under the OP constraints is obtained. Lastly, a distributed RS criterion based on MTP is proposed. In addition, the proposed RS scheme only needs local statistical CSI rather than instantaneous CSI, which makes it simple in implementation. Numerical results demonstrate that the proposed scheme can significantly decrease the power consumption under the predefined OP constraints.
3 February 2019 in Computational Intelligence and Neuroscience
Aiming at the shortcoming of being unsuitable for dynamic background and high computational complexity of the existing RPCA- (robust principal component analysis-) based block-sparse moving object detection method, this paper proposes a two-stage foreground detection framework based on motion saliency for video sequence. At the first stage, the observed image sequence is regarded as the sum of a low-rank background matrix and a sparse outlier matrix, and then the decomposition is solved by the RPCA method via fast PCP (principal component pursuit). At the second stage, the sparse foreground blocks are obtained according to the spectral residuals and the spatial correlation of the foreground region. Finally, the block-sparse RPCA algorithm through fast PCP is used to estimate foreground areas dynamically and to reconstruct the foreground objects. Extensive experiments demonstrate that our method can exclude the interference of background motion and change, simultaneously improving the detection rate of small targets.