Leong Chew Lee

Ms. Leong Chew Lee


Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
8 June 2021 in Polymers
Verified
Journal Article
Open access
PDF file
ADAris Doyan
Aris Doyan
LLLeong Chew Lee
Leong Chew Lee
Muhammad Roil BiladMuhammad Roil Bilad
Muhammad Roil Bilad
KKKiki Adi Kurnia
Kiki Adi Kurnia
SSSusilawati Susilawati
Susilawati Susilawati
KFKajornsak Faungnawakij
Kajornsak Faungnawakij
The increasing rate of oil and gas production has contributed to a release of oil/water emulsion or mixtures to the environment, becoming a pressing issue. At the same time, pollution of the toxic cigarette butt has also become a growing concern. This study explored utilization of cigarette butt waste as a source of cellulose acetate-based (CA) polymer to develop a phase inverted membrane for treatment of oil/water emulsion and compare it with commercial polyvinylidene difluoride (PVDF) and polysulfone (PSF). Results show that the CA-based membrane from waste cigarette butt offers an eco-friendly material without compromising the separation efficiency, with a pore size range suitable for oil/water emulsion filtration with the rejection of >94.0%. The CA membrane poses good structural property similar to the established PVDF and PSF membranes with equally asymmetric morphology. It also poses hydrophilicity properties with a contact angle of 74.5°, lower than both PVDF and PSF membranes. The pore size of CA demonstrates that the CA is within the microfiltration range with a mean flow pore size of 0.17 µm. The developed CA membrane shows a promising oil/water emulsion permeability of 180 L m−2 h−1 bar−1 after five filtration cycles. However, it still suffers a high degree of irreversible fouling (>90.0%), suggesting potential future improvements in terms of membrane fouling management. Overall, this study demonstrates a sustainable approach to addressing oil/water emulsion pollution treated CA membrane from cigarette butt waste.

21 January 2020 in Polymers
Verified
Journal Article
Open access
PDF file
NNNormi Izati Mat Nawi
Normi Izati Mat Nawi
NHNur Syakinah Abd Halim
Nur Syakinah Abd Halim
LLLeong Chew Lee
Leong Chew Lee
MWMohd Dzul Hakim Wirzal
Mohd Dzul Hakim Wirzal
Muhammad Roil BiladMuhammad Roil Bilad
Muhammad Roil Bilad
ZPZulfan Adi Putra
Zulfan Adi Putra
The competitiveness of algae as biofuel feedstock leads to the growth of membrane filtration as one of promising technologies for algae harvesting. Nanofiber membrane (NFM) was found to be efficient for microalgae harvesting via membrane filtration, but it is highly limited by its weak mechanical strength. The main objective of this study is to enhance the applicability of nylon 6,6 NFM for microalgae filtration by optimizing the operational parameters and applying solvent vapor treatment to improve its mechanical strength. The relaxation period and filtration cycle could be optimized to improve the hydraulic performance. For a cycle of 5 min., relaxation period of ≤2 min shows the highest steady-state permeability of 365 ± 14.14 L m−2 h−1 bar−1, while for 10 min cycle, 3 min. of relaxation period was found optimum that yields permeability of 402 ± 34.47 L m−2 h−1 bar−1. The treated nylon 6,6 NFM was also used to study the effect of aeration rate. It is confirmed that the aeration rate enhances the steady-state performance for both intermittent and continuous mode of aeration. Remarkably, intermittent aeration shows 7% better permeability than the full aeration for all tested condition, which is beneficial for reducing the total energy consumption.