Brandsæter LO, Mangerud K & Rasmussen J (2012) Interactions between pre‐ and post‐emergence weed harrowing in spring cereals. Weed Research52, 338–347.Summary: Pre‐ and post‐emergence weed harrowing were studied in spring cereals in different environments and with two types of harrows in Norway during 2004–2006. The objectives were to investigate interactions between pre‐ and post‐emergence weed harrowing and the importance of harrow type. We hypothesised that pre‐ and post‐emergence harrowing interact positively, that a combination gives more stable weed control effects than pre‐ and post‐emergence weed harrowing used alone, and that a harrow type with bent tines is more aggressive and suitable on hard‐packed soils than a harrow with strait tines. The results only supported the last of these hypotheses. Post‐emergence weed harrowing controlled a certain percentage of the present weeds, and this percentage was not dependent on pre‐emergence weed harrowing. On average, pre‐emergence harrowing reduced weed density by 26% and weed biomass by 22%, while the average effect of post‐emergence harrowing was 47% on weed density and 41% on weed biomass. The combined effect of pre‐ and post‐emergence weed harrowing was 61% on weed density and 54% on weed biomass. The combination did not give more stable weed control effects than pre‐ and post‐emergence weed harrowing used alone. Pre‐emergence harrowing increased the average crop yield by 6.2%, post‐emergence harrowing by 4.0% and the combined effect was 10%. Crop yield was mainly increased on hard‐packed soils. Weed and crop responses varied strongly among experiments, but the efficacy of pre‐ and post‐emergence weed harrowing was positively correlated across experiments. Weed species composition was of minor importance regarding weed control. The study indicates that one aggressive post‐emergence cultivation may be as good as one pre‐emergence and one less aggressive post‐emergence cultivation. However, little is known about the interactions between cultivation at different crop and weed growth stages.

Teff is a staple and well adapted crop in Ethiopia. Weed competition and control have major effects on yields and economic returns of the crop in the country. Among the weed management methods, development and use of weed competitive teff varieties remain the cheapest and most sustainable weed management option. Ten teff varieties were tested for their weed competitive ability in two locations. Treatments were applied using a split plot design with three blocks at each location for two consecutive seasons. Hand weeding and non-weeded treatments were applied to whole plot treatments with teff varieties assigned as split plots within the whole plot. The main objective was to determine relative competitive ability among teff varieties. Results showed that teff varieties showed significant variation in their weed competitive abilities. The varieties ‘Kora’ and ‘DZ-Cr-387’ significantly reduced weed density, dry weight, and cover more than the other teff varieties. They also had the lowest yield losses with a loss of 6% in biomass yield and 18% in grain yield recorded from ‘Kora’ and a loss of 17% in biomass yield and 21% in grain yield recorded from ‘DZ-Cr-387’. Therefore, they showed the highest weed competitive ability compared to the other varieties.

Knowledge about the reproduction strategies of invasive species is fundamental for effective control. The invasive Fallopia taxa (Japanese knotweed s.l.) reproduce mainly clonally in Europe, and preventing spread of vegetative fragments is the most important control measure. However, high levels of genetic variation within the hybrid F. × bohemica indicate that hybridization and seed dispersal could be important. In Norway in northern Europe, it is assumed that these taxa do not reproduce sexually due to low temperatures in the autumn when the plants are flowering. The main objective of this study was to examine the genetic variation of invasive Fallopia taxa in selected areas in Norway in order to evaluate whether the taxa may reproduce by seeds in their most northerly distribution range in Europe. Fallopia stands from different localities in Norway were analyzed with respect to prevalence of taxa, and genetic variation within and between taxa was studied using amplified fragment length polymorphism (AFLP). Taxonomic identification based on morphology corresponded with identification based on simple sequence repeats (SSR) and DNA ploidy levels (8× F. japonica, 6× F. × bohemica and 4× F. sachalinensis). No genetic variation within F. japonica was detected. All F. × bohemica samples belonged to a single AFLP genotype, but one sample had a different SSR genotype. Two SSR genotypes of F. sachalinensis were also detected. Extremely low genetic variation within the invasive Fallopia taxa indicates that these taxa do not reproduce sexually in the region, suggesting that control efforts can be focused on preventing clonal spread. Climate warming may increase sexual reproduction of invasive Fallopia taxa in northern regions. The hermaphrodite F. × bohemica is a potential pollen source for the male‐sterile parental species. Targeted eradication of the hybrid can therefore reduce the risk of increased sexual reproduction under future warmer climate.

Eradication of alien invasive species in the soil with steam as an alternative to chemical fumigation may allow contaminated soil to be reused. We have investigated steam disinfestation of soil to combat invasive plant species in three experiments including different temperatures and exposure durations using a prototype stationary soil-steaming device. The experiments included effects on seed germination of bigleaf lupine (Lupinus polyphyllusLindl.), ornamental jewelweed (Impatiens glanduliferaRoyle), and wild oat (Avena fatuaL.; one population from Poland and one from Norway), as well as effects on sprouting rhizome fragments of Canada goldenrod (Solidago canadensisL.) and Bohemian knotweed (ReynoutriaxbohemicaChrtek & Chrtková). In Experiment 1, we tested four different soil temperatures of 64, 75, 79, and 98 C with an exposure duration of 90 s. In Experiments 2 and 3, we tested exposure durations of 30, 90, and 180 s and 90, 180, and 540 s, respectively, at 98 C. Seed pretreatment of 14 d cooling forL. polyphyllusandI. glandulifera, no seed pretreatment and 12-h moistening forA. fatuapopulations, and 5- and 10-cm cutting size forR. xbohemicawere applied. Our results showed germination/sprouting was inhibited at 75 C forI.glandulifera(for 90 s) and 98 C for the other species; however, longer exposure duration was needed forL.polyphyllus. While 30 s at 98 C was enough to killA.fatuaseeds andS.canadensisandR. xbohemicarhizome fragments, 180-s exposure duration was needed to killL.polyphyllusseeds. The results showed promising control levels of invasive plant propagules in contaminated soil by steaming, supporting the steam treatment method as a potential way of disinfecting soil to prevent dispersal of invasive species.

There is a need both in organic farming and on farms using integrated pest management for non-chemical measures that control the perennial weed flora. The effect of mechanical weeding and fertilisation on perennial weeds, fungal diseases and soil structure were evaluated in two different experiments in spring cereals. Experiment I included six strategies. The first strategy was (1) without specific measures against perennial weeds. The other strategies encompassed one or two seasonal control measures; (2) rhizome/root cutting with minimal soil disturbance in autumn, (3) hoeing with 24 cm row spacing, (4) combined hoeing and disc harrowing in autumn, (5) ‘KvikUp’ harrowing in spring, and (6) ‘KvikUp’ harrowing in spring and autumn. Experiment II included factor (i) inter-row hoeing and (ii) fertilisation level. This experiment included the comparison between normal row spacing (12 cm) with weed harrowing versus double row spacing (=24 cm) in combination with inter-row hoeing and 4 fertilisation levels (50–200 kg N ha⁻¹). In experiment I the strategies consisting of no or one direct weed control measure (1, 2, 3 and 5) clearly did not control the perennial weeds. The two seasonal control measures (4 and 6) gave a satisfactory weed control and highest crop yield. The combination of best weed control and no measured harmful effects on soil structure or increase of fungal diseases may explain the highest yields for these strategies. In Experiment II, hoeing and 24 cm spacing gave less perennial biomass compared to 12 cm spacing. Grain yields increased linearly with increasing nitrogen input. The study shows that both inter-row hoeing and weed harrows, are important elements in integrated pest management practice and organic farming. In addition, our results indicate that efficient mechanical weeding is possible without harmful effects in crop rotation consisting of various spring cereals as regards soil structure and plant health.

Tillage controls perennial weeds, such as Elymus repens, partly because it fragments their underground storage organs. However, tillage is difficult to combine with a growing crop, which limits its application. The aim of this study was to evaluate how soil vertical cutting with minimum soil disturbance and mowing affect the growth and competitive ability of E. repens in a grass–clover crop. A tractor-drawn prototype with vertical disks was used to fragment E. repens rhizomes with minimal soil and crop disturbance. In experiments performed in 2014 and 2015 at a field site close to Uppsala, Sweden, the rhizomes were fragmented before crop sowing (ERF), during crop growth (LRF), or both (ERF+LRF). Fragmentation was combined with repeated mowing (yes/no) and four companion crop treatments (none, Italian ryegrass, white clover, and grass/clover mixture). The results showed that in the grass–clover crop, rhizome fragmentation reduced E. repens rhizome biomass production and increased Italian ryegrass shoot biomass. ERF and LRF both reduced E. repens rhizome biomass by about 38% compared with the control, while ERF+LRF reduced it by 63%. Italian ryegrass shoot biomass was increased by 78% by ERF, 170% by LRF and 200% by ERF+LRF. Repeated mowing throughout the experiment reduced E. repens rhizome biomass by about 75%. Combining repeated mowing with rhizome fragmentation did not significantly increase the control effect compared to mowing alone. We concluded that rhizome fragmentation using vertical disks can be used both before sowing and during crop growth to enhance the controlling effect of grass–clover crops on E. repens.