Monitoring changes in forest height, biomass and carbon stock is important for understanding the drivers of forest change, clarifying the geography and magnitude of the fluxes of the global carbon budget and for providing input data to REDD+. The objective of this study was to investigate the feasibility of covering these monitoring needs using InSAR DEM changes over time and associated estimates of forest biomass change and corresponding net CO2 emissions. A wall-to-wall map of net forest change for Uganda with its tropical forests was derived from two Digital Elevation Model (DEM) datasets, namely the SRTM acquired in 2000 and TanDEM-X acquired around 2012 based on Interferometric SAR (InSAR) and based on the height of the phase center. Errors in the form of bias, as well as parallel lines and belts having a certain height shift in the SRTM DEM were removed, and the penetration difference between X- and C-band SAR into the forest canopy was corrected. On average, we estimated X-band InSAR height to decrease by 7 cm during the period 2000–2012, corresponding to an estimated annual CO2 emission of 5 Mt for the entirety of Uganda. The uncertainty of this estimate given as a 95% confidence interval was 2.9–7.1 Mt. The presented method has a number of issues that require further research, including the particular SRTM biases and artifact errors; the penetration difference between the X- and C-band; the final height adjustment; and the validity of a linear conversion from InSAR height change to AGB change. However, the results corresponded well to other datasets on forest change and AGB stocks, concerning both their geographical variation and their aggregated values.
Teff is a staple and well adapted crop in Ethiopia. Weed competition and control have major effects on yields and economic returns of the crop in the country. Among the weed management methods, development and use of weed competitive teff varieties remain the cheapest and most sustainable weed management option. Ten teff varieties were tested for their weed competitive ability in two locations. Treatments were applied using a split plot design with three blocks at each location for two consecutive seasons. Hand weeding and non-weeded treatments were applied to whole plot treatments with teff varieties assigned as split plots within the whole plot. The main objective was to determine relative competitive ability among teff varieties. Results showed that teff varieties showed significant variation in their weed competitive abilities. The varieties ‘Kora’ and ‘DZ-Cr-387’ significantly reduced weed density, dry weight, and cover more than the other teff varieties. They also had the lowest yield losses with a loss of 6% in biomass yield and 18% in grain yield recorded from ‘Kora’ and a loss of 17% in biomass yield and 21% in grain yield recorded from ‘DZ-Cr-387’. Therefore, they showed the highest weed competitive ability compared to the other varieties.
9 January 2012 in Journal of the Science of Food and Agriculture
Weed harrowing is commonly used to manage weeds in organic farming but is also applied in conventional farming to replace herbicides. Due to its whole-field application, weed harrowing after crop emergence has relatively poor selectivity and may cause crop damage. Weediness generally varies within a field. Therefore, there is a potential to improve the selectivity and consider the within-field variation in weediness. This paper describes a decision model for precision post-emergence weed harrowing in cereals based on experimental data in spring barley and nonlinear regression analysis. The model predicts the optimal weed harrowing intensity in terms of the tine angle of the harrow for a given weediness (in terms of percentage weed cover), a given draft force of tines, and the biological weed damage threshold (in terms of percentage weed cover). Weed cover was measured with near-ground RGB images analyzed with a machine vision algorithm based on deep learning techniques. The draft force of tines was estimated with an electronic load cell. The proposed model is the first that uses a weed damage threshold in addition to site-specific values of weed cover and soil hardness to predict the site-specific optimal weed harrow tine angle. Future field trials should validate the suggested model.