This study presents a comprehensive evaluation of Equal Channel Angular Pressing (ECAP) processing on the structural evolution and mechanical properties of AA2xxx aluminum alloy. Finite element analysis (FE) was used to study the deformation behavior of the AA2xxx billets during processing in addition investigate the strain homogeneity in the longitudinal and transverse direction. Billets of AA2011 aluminum alloy were processed successfully through ECAP up to 4-passes with rotating the sample 90° along its longitudinal axis in the same direction after each pass (route Bc) at 150 °C. The microstructural evolution and crystallographic texture were analyzed using the electron back-scatter diffraction (EBSD) and optical microscopy (OM). An evaluation of the hardness and tensile properties was presented and correlated with the EBSD findings and FE simulations. The FE analysis results were in good agreement with the experimental finding and microstructural evolution. Processing through 4-passes produced an ultrafine-grained structure (UFG) and a recrystallized fine grain dominated the structure coupled with a geometric grain subdivision which indicated by grain refining and very high density of substructures. This reduction in grain size was coupled with an enhancement in the hardness, tensile strength by 66.6%, and 52%, respectively compared to the as-annealed counterpart. Processing through 1-pass and 2-passes resulted in a strong texture with significant rotation for the texture components whereas 4-passes processing led to losing the symmetry of the texture with significant reduction in the texture intensity.

The current study presents a detailed investigation for the equal channel angular pressing of pure copper through two regimes. The first was equal channel angular pressing (ECAP) processing at room temperature and the second was ECAP processing at 200 °C for up to 4-passes of route Bc. The grain structure and texture was investigated using electron back scattering diffraction (EBSD) across the whole sample cross-section and also the hardness and the tensile properties. The microstructure obtained after 1-pass at room temperature revealed finer equiaxed grains of about 3.89 µm down to submicrons with a high density of twin compared to the starting material. Additionally, a notable increase in the low angle grain boundaries (LAGBs) density was observed. This microstructure was found to be homogenous through the sample cross section. Further straining up to 2-passes showed a significant reduction of the average grain size to 2.97 µm with observable heterogeneous distribution of grains size. On the other hand, increasing the strain up to 4-passes enhanced the homogeneity of grain size distribution. The texture after 4-passes resembled the simple shear texture with about 7 times random. Conducting the ECAP processing at 200 °C resulted in a severely deformed microstructure with the highest fraction of submicron grains and high density of substructures was also observed. ECAP processing through 4-passes at room temperature experienced a significant increase in both hardness and tensile strength up to 180% and 124%, respectively.

The present study was undertaken to examine the effect of iron, manganese, copper and magnesium on the microstructural characteristics of Al-11%Si-2%Cu-Mg-based alloy referred to as 396 under different working conditions. The results show that strontium (Sr) has high affinity to react with magnesium (Mg), resulting in reduced effectiveness as eutectic silicon modifier or age hardening agent. In addition, Sr alters the sequence of the precipitation of the α-AlFeMnSi phase from post-eutectic to pro-eutectic which would harden the soft α-Aluminum matrix. The mechanism is still under investigation. The interactions between iron (Fe) and Mg and Sr-Mg result in the formation of serval dissolvable intermetallics during the solutionizing treatment such as β-AlFeSi, π-AlFeMgSi and Q-AlMgSiCu phases. The study also emphasizes the role of modification and grain refining as well as intermetallics in porosity formation and hardness of samples aged in the temperature range 155–240 °C.