Diallyl orthophthalate (DAOP) prepolymer was investigated as a reactive plasticizer to improve the processability of thermoplastics. The rheology of blends of DAOP prepolymer initiated by 2,3-dimethyl-2,3-diphenylbutane (DMDPB) and polyphenylene oxide (PPO) was monitored during the curing process, and their thermal properties and morphology in separated phases were also studied. Differential scanning calorimetry (DSC) results showed that the cure degree of the reactively plasticized DAOP prepolymer was reduced with increasing PPO due to the dilution effect. The increasing amount of the DAOP prepolymer led to a gradual decrease in the viscosity of the blends and the rheology behavior was consistent with the chemical gelation of DAOP prepolymer in blends. This indicated that the addition of the DAOP prepolymer effectively improved processability. The phase separation occurring during curing of the blend and the transition from the static to dynamic mode significantly influences the development of the morphology of the blend corresponding to limited evolution of the conversion around the gel point.
BaTi5O11 nanocrystals were synthesized via a sol–gel method employing different organic solvents. The influence of solvent choice on microstructure and photocatalytic performance was investigated through methylene blue (MB) degradation under UV light irradiation. The monoclinic BaTi5O11 nanocrystals were successfully synthesized, where solvent selection significantly affected their grain size and Brunauer–Emmett–Teller (BET) surface area. The BaTi5O11 nanocrystals synthesized using polyethylene glycol-200 (PEG-200) exhibited the highest BET surface area (9.78 m2/g) and smallest average pore size (17.8 nm). The BaTi5O11 nanocrystals also displayed a larger optical bandgap (3.61 eV), attributed to pronounced quantum confinement and surface effects. Consequently, the PEG-200-derived BaTi5O11 photocatalyst achieved complete MB degradation within 30 min under UV light irradiation. This enhanced performance was attributed to the high BET surface area providing abundant active sites. Furthermore, the BaTi5O11 nanocrystal photocatalyst maintained excellent reusability and stability over four consecutive cycles.
The effect of drying, thermal decomposition, and sintering conditions during the sol–gel synthesis of BaTi5O11 nanocrystals was investigated to optimize levofloxacin (LEV) photodegradation. Sintering emerges as the dominant factor, and BaTi5O11 nanocrystals synthesized at 700 °C for 120 min exhibit the smallest grain size, highest specific surface area and abundant active sites, achieving 93.2% LEV degradation within 30 min under UV irradiation. In contrast, excessive sintering temperatures or time induce grain coarsening and size homogenization, which reduce surface area and active sites, thereby impairing photocatalytic performance. The optimized nanocrystals also efficiently degrade other antibiotic pollutants, including ciprofloxacin, norfloxacin, and tetracycline. Radical trapping experiments confirm that •OH is the primary reactive species. Photoluminescence and photoelectrochemical analyses reveal a competition between grain size variation and charge carrier dynamics; however, photocatalytic degradation underscores the dominant role of surface-active sites and specific surface area. Kelvin probe force microscopy (KPFM) further corroborates efficient charge separation, showing a cross-line contact potential difference (ΔVCPD) of approximately 90 mV, indicative of facile hole migration to the crystal surface. Collectively, these findings elucidate the processing–microstructure–property relationships in BaTi5O11 nanocrystals and provide a robust basis for the rational design of high-performance photocatalytic systems for antibiotic pollutant remediation.