An effective maximum power point tracking (MPPT) technique plays a crucial role in improving the efficiency and performance of grid-connected renewable energy sources (RESs). This paper uses the African Vulture Optimization Algorithm (AVOA), a metaheuristic technique inspired by nature, to tune the proportional–integral (PI)-based MPPT controllers for hybrid RESs of solar photovoltaic (PV) and wind systems, as well as the PI controllers in a storage system that are used to smooth the output fluctuations of those RESs in a hybrid system. The performance of the AVOA is compared with that of the widely used the particle swarm optimization (PSO) technique, which is commonly acknowledged as the foundation of swarm intelligence. As a result, this technique is introduced in this study to draw a comparison. It is observed that the proposed algorithm outperformed the PSO algorithm in terms of the tracking speed, robustness, and best convergence to the minimum value. A MATLAB/Simulink model was built, and optimization and simulation for the proposed system were carried out to verify the introduced algorithms. In conclusion, the optimization and simulation results showed that the AVOA is a promising method for solving a variety of engineering problems.
The integration of photovoltaic (PV) into electric power systems has been widely explored and adopted to address the problems associated with the depletion of fossil fuels and the release of greenhouse gases. PV panels convert sunlight into electricity, minimizing the reliance on fossil fuels and mitigating environmental pollution. It is crucial to optimally utilize the PV power in the system; hence maximum power point tracking (MPPT) algorithms have been developed to ensure optimal performance of grid-connected PV systems at the maximum power point (MPP) despite changes in weather conditions. Moreover, deep reinforcement learning (DRL) developments provide a promising approach for optimizing grid-connected PV systems, replacing the conventional proportional-integral-derivative (PID) controllers. However, there is limited research evaluating the efficiency of these systems using DRL techniques. This paper proposes a new dandelion optimizer (DO)-based DRL for MPPT of grid-connected photovoltaic systems and evaluates the proposed method for a 100-MW PV plant connected to a 33-kV distribution system. The proposed DRL technique uses proximal policy optimization (PPO) and deep deterministic policy gradient (DDPG) algorithms for continuous states and discrete or continuous action spaces to adjust the PV-measured voltage based on a reference one produced via DO-PPO and DO-DDPG methods. To test the effectiveness and practicality of the introduced methods, simulations were conducted using actual input data of a 100 MW PV plant connected to a 33-kV distribution system for typical days in summer and winter seasons using MATLAB/Simulink software. The proposed implemented methods were evaluated by comparing their simulation results with other techniques: DO-PID, particle swarm optimization (PSO), and incremental conductance (InC-PI). The findings revealed that the efficiencies of the DC-DC boost and the voltage source converters using the introduced methods were 84.25%-85.90%, and 78.33%-81.10% on a summer day while they were 92.77%-95% and 86.70%-89.50% on a winter day, respectively, which proves that these methods were efficient and effective, indicating their promising potential for future applications.
The efficiency of grid-connected photovoltaic (PV) systems can be improved using a suitable maximum power point tracking (MPPT) control. Many MPPT techniques have been developed. However, when atmospheric conditions change rapidly, the PV modules respond nonlinearly and the performance of these methods especially the conventional ones is significantly reduced. Therefore, to successfully pursue the maximum power point (MPP) in PV systems, a robust MPPT integrated with sliding mode control (SMC) is employed. This paper proposes a circle search algorithm based super twisting SMC (CSA-STSMC) for tracking the MPP for 100-kW of different commercial grid-connected PV modules coupled with an energy storage system that used to smooth their output fluctuations. Moreover, the STSMC and PI controllers’ gains are optimized using the CSA and Grey Wolf Optimizer (GWO) methods and the performance of proposed method is demonstrated through comparisons with CSA based Proportional-Integral controller (CSA-PI), GWO-STSMC, and Incremental Conductance based PI controller (InC-PI) methods. The optimization and simulation analysis are executed in A MATLAB/Simulink environment. It is observed that the proposed method outperforms the considered methods in terms of robustness, tracking speed, best convergence to the minimum error’s value and better tracking efficiency in the maximizing the extracted power from the introduced PV systems.
1 January 2019 in International Journal of Smart Grid and Clean Energy
In electrical distribution systems, shunt capacitors are installed in order to reduce system losses, to enhance the voltage profile, and to free up system capacity. Nevertheless, the installation of shunt capacitors in distribution systems with distorted waveforms will magnify the distortion level of harmonics if they are not set at appropriate locations relative to the harmonics. This paper proposes a hybrid method to determine the placement and sizing of shunt capacitors in distorted radial distribution systems, taking into account the presence of harmonic distortion with consideration of ambient temperature effects, (this technique consists of the fuzzy expert system approach and the Genetic Algorithm method). This hybrid technique is applied to an IEEE 34-bus radial standard distribution system as well as a real distribution system in the Saudi Electricity Company. The simulation results show that harmonic distortion considerably reduces and the efficiency of distribution systems increases with a reduction in power loss and enhancement of voltage regulation.
Distributed grid-connected photovoltaic (PV) generation explores several methods that produce energy at or near the point of consumption, with the aim of reducing electricity losses among transmission networks. Consequently, home on-grid PV applications have garnered increased interest from both scientific researchers and industry professionals over the last decade. Nevertheless, the growing installation of intermittent nature residential PV systems (R-PV) in low-voltage distribution networks is leading to more cautious considerations of technology limitations and PV design challenges. This conservative perspective arises from the standpoint of grid quality and security, ultimately resulting in the revocation of PV connection authorization. Hence, the design of R-PV systems should consider not only the specifications of the PV panels and load profiles but also the characteristics and requirements of the connected power grid. This project therefore seeks to enhance the design considerations of grid-connected PV systems, in order to help the end-users meet the grid codes set out by the Saudi Electricity Regulatory Authority (SERA). Since the maximum amount of generated power is essential for PV system optimization, the ratio of grid strength to maximum transmitted power was employed to ascertain the suitable capacity of the PV system, while the assessment of PV power output was utilized to specify the system size. Furthermore, a battery energy storage system (BESS) with a small size (~10% of the PV capacity) is employed to enhance the PV power quality for a dependable grid interconnection. The BESS is equipped with a versatile power controller in order to achieve the designed objectives. The obtained results show an essential advancement in terms of power quality and reliability at the customer’s connection point. Moreover, with the design assessment process, the low-voltage ride-through (LVRT) and power factor requirements can be met, in addition to the total harmonic distortion (THD) and frequency transient limitations. The proposed solution assists end-users in efficiently designing their own R-PV systems while ensuring quality and sustainability for authorized grid interconnection.