This work proposes a differential evolution algorithm to control a vehicle-to-grid (V2G) system based on photovoltaic generation and energy cost curves, and constraints associated with the power converters’ operation, battery charging strategy, and initial budgets. The algorithm is designed to trade off the batteries’ state of charge and the profits gained from selling energy to the grid. To achieve this balance, a fuzzy controller is employed and acts based on forecasts of the photovoltaic generation and the cost of electricity, within prediction windows of 120 min, adapting the batteries’ rate of charging or discharging. Simulation results show that for different curves and different initial budgets, the target state of charge is reached at the end of the time horizon. By evaluating the proposed scheme under different scenarios, the algorithm’s performance is proven to be suitable for future practical deployment.
The work consists of the development of a market-friendly 600 W photovoltaic battery-less water pumping system. The system is composed of four 280 Wp solar panels, an auxiliary 10 W solar panel, a three-phase converter and a ½ horsepower (hp) submersible water pump. The electronic stage involves a resonant DC-DC converter in series with a voltage source three-phase inverter. The novelties of this work are related to the use of a resonant DC-DC converter with fixed duty-cycle and frequency for water pumping application, the use of Silicon Carbide Metal-Oxide-Semiconductor Field-Effect Transistors (MOSFETs) for solving converter startup issues, and the use of a constant voltage maximum power tracking (MPPT) algorithm with auxiliary panels. The work displays the design of the converter, simulation and experimental results, discussions, and cost evaluation. The feasibility of the system is studied for the water requirements of a beef cattle farm in Brazil.
This work compares the performance of two embedded FPGA controllers that can be used in Active Parallel Power Filters (APPF). Both controllers are validated through the FPGA-in-the-loop (FIL) technique, the algorithm’s synthesis is accomplished using the Quartus II® platform, and the board used is from Altera®—Cyclone IV DE2-115. The main difference between the controllers resides in the power theories used to obtain the currents for compensation. The results confirm that the FPGA is a suitable digital device for the parallel operation of multiple compensators and calculation stages, being a viable solution for the requirements imposed in the control of APPF. Furthermore, the effectiveness of the FIL technique for validating the operation of digital circuits and control systems is also confirmed. Finally, a comparison between the processing costs of each of the implemented power theories is presented to guide novel proposals.