The design of a wideband circularly polarized pixelated dielectric resonator antenna using a real-coded genetic algorithm (GA) is presented for far-field wireless power transfer applications. The antenna consists of a dielectric resonator (DR) which is discretized into 8 × 8 grid DR bars. The real-coded GA is utilized to estimate the optimal heights of the 64 DR bars to realize circular polarization. The proposed antenna is excited by a narrow rectangular slot etched on the ground plane. A prototype of the proposed antenna is fabricated and tested. The measured −10 dB reflection and 3 dB axial ratio bandwidths are 32.32% (2.62–3.63 GHz) and 14.63% (2.85–3.30 GHz), respectively. A measured peak gain of 6.13 dBic is achieved at 3.2 GHz.
In this paper, a method for calculating the received power in a radio-frequency wireless power transfer system with array antennas is proposed. The received power is derived based on the superposition of the electric fields that radiate from individual transmitter (Tx) elements and are captured by each receiver (Rx) element. That is expressed in a finite series form with the radiation patterns of an element considering mutual coupling in the array and corresponding distances between the elements of Tx and Rx. Unlike conventional methods (such as the Friis and Goubau formulas), this approach is able to calculate the received power precisely in both Fresnel and far-field regions. It is also efficiently applicable to various cases, such as those involving beamforming and with varying positions of Rx. The calculated results using this method are applied to a 5.2 GHz WPT system with array antennas and verified through comparisons with both simulation and experimental results.
A compact single-fed circularly polarized dielectric resonator antenna (DRA) with an enhanced 3-dB axial ratio bandwidth (ARBW) and gain is proposed. The DRA is implemented by joining a smaller dielectric resonator (DR) to one side wall of a main rectangular DR and is excited by an offset vertical metallic strip. With this configuration, two sets of degenerate orthogonal modes, the TE111 mode and TE113 mode, are simultaneously excited to realize wideband circular polarization operation. Furthermore, by removing a small DR portion from the lower corner of the main DR, the boresight gains at higher frequencies are significantly enhanced. An antenna prototype is fabricated and measured to verify the performance of the proposed design. The experimental results illustrate that the proposed antenna achieves a measured 3-dB ARBW of approximately 44.73% (3.68–5.80 GHz) in conjunction with a broad –10 dB impedance bandwidth of 69.66% (2.9–6.0 GHz). The measured boresight gain is found to be 5.49±0.85 dBic within the passband with a maximum value of 6.34 dBic at 4.7 GHz. Moreover, reasonable agreement between the simulated and measured results is achieved.
In this article, a high gain and compact 4 × 4 circularly polarized microstrip patch antenna array is reported for the data transmission of the next-generation small satellite. The radiating element of the circularly polarized antenna array is realized by the conventional model of the patch with truncated corners. A compact two-stage sequential rotational phase feeding is adopted that broadens the operating bandwidth of the 4 × 4 array. A small stub is embedded in the sequential rotational feed, which results in better performance in terms of the S-parameters and sequential phases at the output ports than sequential rotational feed without open stub. A prototype of the array is fabricated and measured. Fulfilling the application requirements of the next-generation small satellites, the array has the left-handed circularly polarized gain of more than 12 dBic with the axial ratio level below 1.5 dB in the ±10 angular space with respect to the broadside direction for the whole bandwidth from 8.05 GHz to 8.25 GHz. Moreover, the left-handed circularly polarized gain varies from 15 to 15.5 dBic in the desired band. The radiation patterns are measured; both the co- and X-pol are validated.
A co-design consisting of a filtering antenna integrating a cavity-backed patch antenna and a low-pass coaxial filter is proposed for size reduction of the RF front-end. The cavity-backed patch antenna is developed to exhibit a broad impedance bandwidth and a unidirectional radiation pattern. The low-pass coaxial filter is implemented to suppress harmonic resonances and gain in the stop-band of the antenna and is embedded directly inside the antenna cavity to realize a compact small-footprint co-designed filtering antenna structure. Two prototypes of the proposed filtering antennas, which integrate cavity-backed patch antennas with 4 th and 5 th order low-pass coaxial filters and with the overall dimensions of 0.697λ 0 × 0.585λ 0 × 0.236λ 0 and 0.697λ 0 × 0.585λ 0 × 0.320λ 0 (where λ 0 is the free space wavelength at 3.15 GHz), respectively, are fabricated and measured. The experimental results show fractional bandwidths of 25% and 23.8% and gain suppression levels exceeding 11 dB and 22 dB in the stop-bands for the filtering antennas with the 4 th and 5 th order filters, respectively. The measured gain is more than 6.5 dBi in the pass-band for both filtering antennas. In addition, excellent agreement is obtained between the simulated and measured results.
This paper presents a low-profile magneto-electric (ME) dipole antenna with an enhanced impedance bandwidth realized by the loading of shorting parasitic elements. The antenna contains a horizontal planar electric dipole antenna, a Γ-shaped shorted patch antenna, a pair of parasitic L-shaped shorted patches, and a direct feed. By loading of the parasitic L-shaped patches such that they are shorted to the ground, the proposed antenna attains a significant bandwidth enhancement while maintaining excellent broadside radiation characteristics. An antenna prototype with a low profile of only 0.11λ 0 was fabricated and tested ( λ 0 is the free-space wavelength referring to the center frequency). The antenna achieves a measured impedance bandwidth of 75.64% (1.34-2.97 GHz) for a voltage standing wave ratio (VSWR) of less than 2. Within the operating band, the measured gain ranges from 6.23 to 8.49 dBi. Additionally, stable radiation patterns on both E- and H-planes with a high front-to-back ratio of more than 20.5 dB are achieved.