Abraham Sanchez

Dr. Abraham Sanchez

TecNM/CENIDET
orcid

Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
12 June 2024 in Technologies
Verified
Journal Article
Open access
HAHeriberto Adamas-Pérez
Heriberto Adamas-Pérez
Mario Ponce-SilvaMario Ponce-Silva
Mario Ponce-Silva
JMJesús Mina
Jesús Mina
Abraham SanchezAbraham Sanchez
Abraham Sanchez
OROmar Rodríguez-Benítez
Omar Rodríguez-Benítez
OROscar Miguel Rodríguez-Benítez
Oscar Miguel Rodríguez-Benítez
This paper aims to propose a new sizing approach to reduce the footprint and optimize the performance of an LCL filter implemented in photovoltaic systems using grid-connected single-phase microinverters. In particular, the analysis is carried out on a single-phase full-bridge inverter, assuming the following two conditions: (1) a unit power factor at the connection point between the AC grid and the LCL filter; (2) a control circuit based on unipolar sinusoidal pulse width modulation (SPWM). In particular, the ripple and harmonics of the LCL filter input current and the current injected into the grid are analyzed. The results of the Simulink simulation and the experimental tests carried out confirm that it is possible to considerably reduce filter volume by optimizing each passive component compared with what is already available in the literature while guaranteeing excellent filtering performance. Specifically, the inductance values were reduced by almost 40% and the capacitor value by almost 100%. The main applications of this new design methodology are for use in single-phase microinverters connected to the grid and for research purposes in power electronics and optimization.

31 December 2020 in Electronics
Verified
Journal Article
Open access
PDF file
Mario Ponce-SilvaMario Ponce-Silva
Mario Ponce-Silva
Daniel Salazar-PérezDaniel Salazar-Pérez
Daniel Salazar-Pérez
Oscar Rodríguez BenítezOscar Rodríguez Benítez
Oscar Rodríguez Benítez
LVLuis Gerardo Vela-Valdés
Luis Gerardo Vela-Valdés
Abraham SanchezAbraham Sanchez
Abraham Sanchez
Juan AquiJuan Aqui
Juan Aqui
The main contribution of this paper is to show a new AC/DC converter based on the rearrangement of the flyback converter. The proposed circuit only manages part of the energy and the rest is delivered directly from the source to the load. Therefore, with the new topology, the efficiency is increased, and the stress of the components is reduced. The rearrangement consist of the secondary of the flyback is placed in parallel with the load, and this arrangement is connected in series with the primary side and the rectified voltage source. The re-arranged flyback is only a reductive topology and with no magnetic isolation. It was studied as a power supply for LEDs. A low frequency averaged analysis (LFAA) was used to determine the behavior of the proposed circuit and an equivalent circuit much easier to analyze was obtained. To validate the theoretical analysis, a design methodology was developed for the re-arranged flyback converter. The designed circuit was implemented in a 10 W prototype. Experimental results showed that the converter has a THDi = 21.7% and a PF = 0.9686.

23 November 2020 in Electronics
Verified
Journal Article
Open access
PDF file
Oscar Rodríguez BenítezOscar Rodríguez Benítez
Oscar Rodríguez Benítez
Mario Ponce-SilvaMario Ponce-Silva
Mario Ponce-Silva
Juan AquiJuan Aqui
Juan Aqui
Abraham SanchezAbraham Sanchez
Abraham Sanchez
LVLuis Gerardo Vela-Valdés
Luis Gerardo Vela-Valdés
Claudia Cortes-GarciaClaudia Cortes-Garcia
Claudia Cortes-Garcia
This paper focuses on the main reasons of low efficiency in a current-fed DC-DC resonant converter applied to photovoltaic (PV) isolated systems, comparing the effects derived by the overlapping time in the gate-signals (gate-source voltage) combining silicon (Si), silicon carbide (SiC), and gallium nitride (GaN)-based power devices. The results show that unidirectional switches (metal–oxide–semiconductor field-effect transistors (MOSFETs) plus diode) present hard switching as a result of the diode preventing the MOSFET capacitance of being discharged. The effectiveness of the converter was verified with a 200-W prototype with an input voltage range of 0–30.3 V, an output voltage of 200 V, and a switching frequency of 200 kHz. The reduction losses by applying GaN versus Si and SiC technologies are 66.49% and 53.57%, respectively. Alternatively, by applying SiC versus Si devices the reduction loss is 27.84%. Finally, according to the results, 60% of losses were caused by the diodes on both switches.

Verified
Journal Article
Open access
PDF file
Iván Alfonso Reyes-PortilloIván Alfonso Reyes-Portillo
Iván Alfonso Reyes-Portillo
Abraham SanchezAbraham Sanchez
Abraham Sanchez
JMJorge Alberto Morales-Saldaña
Jorge Alberto Morales-Saldaña
JMJesús Mina
Jesús Mina
ENEdgardo Netzahuatl
Edgardo Netzahuatl
EREricka Reyes-Sánchez
Ericka Reyes-Sánchez
The excessive use of fossil fuels has caused great concern due to modern environmental problems, particularly air pollution. The above situation demands that different areas of research aim at a sustainable movement to reduce CO2 emissions caused by non-renewable organic fuels. A solution to this problem is the use of Electric Vehicles (EV) for mass transportation of people. However, these systems require high-power DC/DC converters capable of handling high current levels and should feature high efficiencies to charge their batteries. For this application, a single-stage converter is not viable for these applications due to the high current stress in a switch, the low power density, and its low efficiency due to higher switching losses. One solution to this problem is Multiphase Converters, which offer high efficiency, high power density, and low current ripple on the battery side. However, these characteristics are affected by the current imbalance in the phases. This paper is focused on the study of the effects of the current imbalance in a Multiphase Buck Converter, used as an intermediate cover between a power supply and the battery of an EV. Analyzing the efficiency and thermal stress parameters in different scenarios of current balance and current imbalance in each phase.

6 March 2025 in Electricity
Verified
Journal Article
Open access
PDF file
MTMa. Del Carmen Toledo-Pérez
Ma. Del Carmen Toledo-Pérez
RVRodolfo Amalio Vargas-Méndez
Rodolfo Amalio Vargas-Méndez
Abraham SanchezAbraham Sanchez
Abraham Sanchez
GLORIA LILIA OSORIO GORDILLOGLORIA LILIA OSORIO GORDILLO
GLORIA LILIA OSORIO GORDILLO
LVLuis Gerardo Vela-Valdés
Luis Gerardo Vela-Valdés
OROmar Rodriguez
Omar Rodriguez
In this article, a comprehensive review of electrical microgrids is presented, emphasizing their increasing importance in the context of renewable energy integration. Microgrids, capable of operating in both grid-connected and standalone modes, offer significant potential for providing energy solutions to rural and remote communities. However, the inclusion of diverse energy sources, energy storage systems (ESSs), and varying load demands introduces challenges in control and optimization. This review focuses on hybrid microgrids, analyzing their operational scenarios and exploring various optimization strategies and control approaches for efficient energy management. By synthesizing recent advancements and highlighting key trends, this article provides a detailed understanding of the current state and future directions in hybrid microgrid systems.

19 June 2020 in International Journal of Hydrogen Energy
Verified
Journal Article
Closed access
MLM. López-Pérez
M. López-Pérez
Abraham SanchezAbraham Sanchez
Abraham Sanchez
UCU. Cano-Castillo
U. Cano-Castillo
FLF. Loyola-Morales
F. Loyola-Morales