The present research work had the goal of assessing the use of ultrasound for determining the physical-mechanical properties of clear wood in Eucalyptus camaldulensis from a 5-year-old forest stand located in the municipality of Sinop, Mato Grosso State, Brazil. The selection of trees was carried out according to the diameter at breast height (DBH) and height (H). Forty trees were harvested and a 2 m long log was obtained from each tree for the assessment of physical-mechanical properties. In physical properties, the specific gravity, shrinkage (radial, tangential and volumetric) and anisotropic factor were determined. The dynamic modulus of elasticity (MOE) was estimated by ultrasound applied in the longitudinal direction of the samples. The highest correlation with the mechanical test results was found for dynamic MOE, with R2 values in the range of 0.30–0.75. Wood density was highly positively correlated with the dynamic MOE of the wood. The use of ultrasound as a non-destructive method was feasible to determine the selected physical-mechanical properties of Eucalyptus camaldulensis wood as a function of propagation speed and the MOE dynamic in most of the assays.
Banana and bergamot peels are underutilized byproducts of the essential oil and juice-processing industry. This study was designed for the development of rigid polyurethane foam (RPUF) composites using polysaccharide-rich fruit peels as fillers. These fillers were characterized for chemical properties using wet analyses. Additionally, the influences of the filler type and filler content on morphological, thermal, mechanical, hygroscopic, and colorimetric properties of the RPUF were investigated. The main results indicated that, in a comparison with the neat RPUF, the insertion of up to 15% of fillers yielded similar water uptake, apparent density, compressive strength, and color properties, as well as increases up to 115% in thermal stability and up to 80% in cell size.
The impregnation of low-molecular-weight monomers prior to polymerize them inside the wood may be an efficient way to improve some important wood properties. This work aimed to determine some technological properties of wood-based composites (WPC) produced by in situ polymerization, using a pine wood (Pinus elliottii Engelm.) impregnated with methyl methacrylate (MMA). For that, samples taken from both juvenile (JV) and mature (MT) pine woods were treated with MMA. Physical, mechanical, chemical, thermal and morphological features were evaluated. MMA-treated woods from both juvenile and mature woods presented superior physical, mechanical (expect brittleness) and thermal properties when compared to pristine ones. The infrared spectra and morphological analysis by scanning electron microscopy (SEM) confirmed the presence of the monomer inside the pine wood. The juvenile wood presented higher treatability than the mature wood, due to its higher content of intra- and inter-cellular spaces.
The use of lignocellulosic fillers in rigid polyurethane foams (RPUFs) has been receiving great attention due to their good mechanical and insulation properties and the high sustainable appeal of the obtained cellular polymers, although high water uptakes are found in most of these systems. To mitigate this detrimental effect, RPUFs filled with wood flour (2.5% wt) were fabricated with the addition of furfuryl alcohol (FA) to create a polymer grafted with the wood filler. Two concentrations of FA (10 wt% and 15 wt%) were investigated in relation to the wood flour, and the RPUFs were characterized for cell morphology, density, compressive properties, thermal stability, and water uptake. The introduction of wood flour as a filler decreased the cell size and increased the anisotropy index of the RPUFs and, in addition to that, the FA grafting increased these effects even more. In general, there were no significant changes in both mechanical and thermal properties ascribed to the incorporation of the fillers. On the other hand, a reduction of up to 200% in water uptake was ascribed to the FA-treated fillers.
6 March 2024 in Journal of the Indian Academy of Wood Science