25 June 2020 in IEEE Transactions on Industrial Electronics
The doubly salient electromagnetic machine (DSEM) is a suitable candidate in many industrial applications due to its simple construction and low manufacture cost. However, the doubly salient structure and the conventional square-wave control method lead to the large torque ripple in the DSEM. In this paper, an improved direct instantaneous torque control (DITC) method is proposed to suppress the inherent torque ripple and enhance the torque capability of the DSEM. The maximum torque characteristics of the DSEM are obtained and analyzed with the finite element method (FEM). Besides, the ideal phase current waveform to realize the low torque ripple is constructed according to the maximum torque characteristics. Then, the operation principle of the proposed DITC method is derived from the maximum torque characteristics. The proposed DITC method is implemented on a prototype of 12/8-pole DSEM drive system. The influence of the commutation angle parameters on the proposed DITC method is analyzed through simulation and experimental results. The simulation and experimental results indicate that the proposed DITC method can realize the smooth torque operation and high torque-ampere ratio simultaneously. Finally, the simulation and experiment under the step reference torque condition are performed to tested the dynamic performance of proposed DITC method.
12 May 2020 in IEEE Transactions on Industrial Electronics
30 October 2019 in IEEE Transactions on Industrial Electronics
23 October 2019 in IEEE Transactions on Power Electronics
21 April 2020 in IEEE Transactions on Industrial Electronics
A doubly salient electromagnetic starter/ generator (DSESG) system based on the bidirectional converter (BDC) is proposed. The BDC is operated as an inverter in starting mode and as an active rectifier (AR) in generation mode. Compared to the conventional DSESG system, which is based on an inverter and a diode rectifier or a discrete inverter/rectifier unit (IRU), the configuration is simplified and the weight is reduced. Since the output voltage is improved by the angular position control (APC), field and phase currents are re-distributed. The copper loss optimization control (CLOC) for the AR is proposed. The copper loss is analyzed based on the extreme learning machine (ELM) and the turn-off angles are selected. The copper loss is minimized and the heat is reduced. The copper loss and heat generation are also balanced in the field and phase windings to decrease the temperature of the field windings at low speed. Experimental verifications are conducted on a 9kW DSESG prototype. The effectiveness of the proposed ELM-based CLOC is verified by simulation and experiments. A lighter and simpler DSESG system with reduced loss is presented.
1 June 2020 in IEEE Transactions on Energy Conversion
A DC-link voltage regulation method is proposed based on capacitor energy control (CEC) for the doubly salient electro-magnetic generator (DSEG) system. Instead of tracking the DC-link voltage, the stored energy in the DC-link capacitor is set as the control target in the outer loop. A proportional component that converts the command output current into the command field current is developed between the capacitor energy loop and field current loop. The coefficient in the proportional component is investigated based on the mathematical model of the 12-8 pole DSEG, considering the load and speed variation. The dynamic response of the DSEG system is accelerated and the DC-link voltage variation is reduced with the proposed method. Furthermore, the adaptability to speed variation of the controlled is optimized. Since the DC-link capacitance is an additional parameter, the influences of capacitor degradation are investigated. The conventional voltage control and the CEC are implemented and compared on a DSEG platform. The optimized performance of the proposed method is verified by both finite element analysis (FEA) and experiments. The proposed method provides optimized dynamic performance over the entire speed range, enabling the DSEG system as a competitive option in the aircraft application.