25 June 2020 in IEEE Transactions on Industrial Electronics
The doubly salient electromagnetic machine (DSEM) is a suitable candidate in many industrial applications due to its simple construction and low manufacture cost. However, the doubly salient structure and the conventional square-wave control method lead to the large torque ripple in the DSEM. In this paper, an improved direct instantaneous torque control (DITC) method is proposed to suppress the inherent torque ripple and enhance the torque capability of the DSEM. The maximum torque characteristics of the DSEM are obtained and analyzed with the finite element method (FEM). Besides, the ideal phase current waveform to realize the low torque ripple is constructed according to the maximum torque characteristics. Then, the operation principle of the proposed DITC method is derived from the maximum torque characteristics. The proposed DITC method is implemented on a prototype of 12/8-pole DSEM drive system. The influence of the commutation angle parameters on the proposed DITC method is analyzed through simulation and experimental results. The simulation and experimental results indicate that the proposed DITC method can realize the smooth torque operation and high torque-ampere ratio simultaneously. Finally, the simulation and experiment under the step reference torque condition are performed to tested the dynamic performance of proposed DITC method.
13 January 2020 in IEEE Transactions on Energy Conversion
The preformed flat wire winding is widely applied in doubly salient brushless DC generator with a rectangular slot structure due to the high slot filling factor and processing efficiency. The windings are commonly identified as the hottest component. The slot leakage is serious in the doubly salient structure machine, which increases the AC copper loss and thermal load of flat wire winding. Hence, predicting and lowering windings temperature are crucial tasks in the design of a doubly salient brushless DC generator with a flat wire winding. This paper proposes the thermal modeling method of flat wire winding, where uneven AC copper loss distribution and thermal resistance between stator and winding are considered. Besides, the thermal model is simplified by canceling the local coordinate system. The characteristics of the temperature distribution of flat conductor winding under water-cooled and fan-cooled conditions are analyzed. Since the thermal resistance between stator and winding prevents the transfer of heat from the winding to the stator, the fan-cooled method is a better choice for the flat conductor winding. Finally, the thermal resistance measurement experiment is the design, and the fan-cooled brushless DC machine with flat conductor winding is developed. The analysis is verified through experiment.
15 August 2018 in IEEE Transactions on Industrial Electronics
A new hybrid excitation brushless dc generator (HEBLDCG) consisting of structure-parallel permanent magnet machine part and flux modulation machine part is proposed in this paper. Based on the flux modulation effect, the permanent magnet machine and flux modulation machine parts, which have different operating principles, can be combined. In addition, the proposed HEBLDCG features a lower short-circuit current by regulating field current, which increases reliability. The operating modes of flux modulation machine part are fully analyzed under different conditions. Changes in the phase shift factor of the permanent magnet machine part caused by the operating modes of the flux modulation machine part are investigated. Further, the proposed HEBLDCG features constant voltage output at a wide range of speeds. Finally, a prototype HEBLDCG is designed and manufactured. The experimental data agree with the simulated data. Loss breakdown is analyzed and efficiency is measured. An HEBLDCG with a reliable diode rectifier is promising for application in on-board dc power generation systems.
30 October 2019 in IEEE Transactions on Industrial Electronics
12 May 2020 in IEEE Transactions on Industrial Electronics
23 October 2019 in IEEE Transactions on Power Electronics