10 April 2024 in IEEE Microwave and Wireless Technology Letters
This letter presents the design of a Doherty power amplifier (DPA) for satellite applications in the $Ka$ -band downlink (17.3–20.3 GHz) implemented on a 100-nm GaN–Si HEMT technology. The design aims to achieve high gain and very high intrinsic linearity over a wide bandwidth of 3 GHz. The experimental characterization on the fabricated chip demonstrates that the DPA can maintain a noise-to-power ratio (NPR) higher than 25 dB and power-added efficiency (PAE) of 30% while providing 36 dBm of output power, when tested with a 100-MHz uniformly distributed signal, achieving state-of-the-art performance among the integrated power amplifiers for satellite communications.
24 October 2024 in IEEE Transactions on Circuits and Systems I: Regular Papers
This study investigates the impact of nonlinear capacitances of SiGe-HBT technology on the stability of power amplifier (PA) designs for 17.3–21.2 GHz satellite communication applications. Various nonlinear capacitances are considered and compared. The pronounced influence of the nonlinear base-collector diffusion capacitance ( C bc,D) on large-signal stability of PAs is analyzed and derived mathematically using simplified circuit models. For more complicated circuitry such as transformer-based PAs, advanced stability analysis techniques based on harmonic balance are reviewed, clarified, and applied to detect the large-signal instability in simulations and to design stabilization networks. Two PA examples with different damping characteristics are designed and evaluated. Simulation results of the unstable PA example (PA_v1) validate the impact of the nonlinear C bc,D on stability. In addition, a strong agreement between the measured spectra of the PA_v1 and simulations validates the efficacy of the adopted stability check methods. Moreover, the stable PA (PA_v2) achieves a saturated output power ( P sat) of 22.8 dBm with power-added efficiency (PAE) of 37.7% at 18.8 GHz and 22.8 dBm with PAE of 37.2% at 19.25 GHz. At a noise power ratio of 15 dB, it delivers 18.6-dBm output power ( P out) with greater than 20% PAE, at both 18.8 and 19.25 GHz. Meanwhile, for specific DVB-S2 16-APSK signal with 100 MBd, roughly 22-dBm average output power ( P avg) with greater than 32% PAE is delivered, at EVM level of $-$ 16 dB (15.8%).
18 October 2024 in IEEE Microwave and Wireless Technology Letters
The European Space Agency (ESA) has designed a 70–95 GHz gallium-nitride-on-silicon (GaN-on-Si) monolithic microwave integrated circuit (MMIC) low noise amplifier (LNA) for future spaceborne cloud profiling radar (CPR) instruments at 94 GHz, like Wivern. The MMIC LNA has also been designed to be compatible with the $W$ -band telecommunication feeder down (71–76 GHz) and up-links (81–86 GHz). The MMIC test results show an average noise figure of 3.9 dB and an average gain of 22.5 dB. The minimum measured noise figure is 2.8 dB at 77 GHz. The MMIC was subject to an input overdrive test and survived the application of a pulsed CPR representative signal with a level of $+$ 23 dBm without showing any subsequent malfunction. To the best knowledge of the authors, these results show: 1) the best overall performance for any GaN-on-Si LNA reported to date in the 70–95 GHz range and 2) the first reporting in the open literature of an input overdrive test in a W-band GaN LNA.