15 November 2022 in IEEE Transactions on Vehicular Technology
In the wireless charging system of EVs, the traditional single-stage LC resonance network has the issues of narrower of parameter design and small equivalent input impedance. While the composite resonant network will introduce additional resonant capacitors and inductors, which increases the system volume, cost, and reduces the efficiency. This paper proposes a design scheme of double-sandwich magnetic coupling structure with a low cross-coupling coefficient, which integrates the resonant inductors into the power transmitter and receiver, and it is designed taking the magnetic leakage and loss as constraints. A 500W prototype is built, and the comparison of experimental efficiencies between the double-sandwich and the separate magnetic coupling structures is performed. Finally, the effectiveness of the integrated design scheme is validated.
12 June 2024 in IEEE Transactions on Industrial Electronics
Rotor-unmanned aerial vehicle (UAV) wireless charging systems require low stray magnetic field distribution characteristics. This article proposes a bipolar four-coil structure and a four-solenoid receiving structure for the UAV wireless charging system. Specifically, employing Biot–Savart's law, the microelements of the coil are decomposed to ascertain that a four-coil distribution can generate a horizontal magnetic field while maintaining lower stray magnetic field distribution characteristics. The optimal winding connection scheme for the four-solenoid structure is also determined. The finite element analysis confirms that the proposed structure can reduce external stray magnetic field by 89% compared with the unipolar structure. A 380 W prototype is constructed, achieving a maximum transmission efficiency of 87.54%. Finally, experimental results verify the feasibility and effectiveness of the proposed magnetic coupling structure.
15 July 2024 in IEEE Journal of Emerging and Selected Topics in Power Electronics
An "E+Ǝ" cores 2-phase magnetic integrated transformers’ structure is presented. The transformers’ core is assembled with two pieces of "E" core of shorted central legs and one piece of "+" core. The 2-phase windings are wound on the upper and lower legs of the "+" core respectively. The manufactured windings are put around the upper and lower legs of the "+" core very easily. The flux excited by each phase’s windings is separated as two smaller parts, they pass through the two "E" cores respectively, which lead to smaller air gap and air gap fringing flux. The windings do not surround the air gaps, the air gap fringing flux does not cause or cause less eddy current loss in windings. The "E+Ǝ" transformers’ magnetic circuit model is established, their parameters are designed, and the losses are calculated. The proposed "E+Ǝ" transformers are verified with simulation and system experiment. Compared with traditional double "EƎ" transformers, the "E+Ǝ" transformers’ secondary winding length and corresponding copper loss will increase a little, but their core volume and core loss will decrease more. When 2-phase parallel LLC resonant converter adopts the "E+Ǝ" transformers, its efficiency will increase compared with adopting double "EƎ" transformers.
1 February 2026 in IEEE Transactions on Industrial Electronics
1 January 2026 in IEEE Transactions on Power Electronics