This paper presents a 1.7-mW low-intermediate-frequency receiver design for Bluetooth low-energy (BLE) applications. The design exploits particular aspects of BLE, such as the relaxed in-band interference characteristics, more precisely the C/I₁ MHz, and the relatively high-frequency-shift keying modulation index, to deliver a high level of energy efficiency and simplicity to the receiver baseband architecture. Reliable quadrature signals are generated in the RF signal path without consuming energy, which is supported by an inverter-based low-noise amplifier (LNA) that achieves high gain and low noise figure under low-power budgets. A small-signal analysis of low-power inverter-based LNAs is presented offering simple design equations. Seeking an affordable solution, the fabricated prototype is fully integrated into an earlier generation CMOS technology node (0.13 μm), occupying a silicon area smaller than 0.7 mm². The receiver achieves a sensitivity level of -92 dBm while consuming 1.41 mA from a 1.2-V supply.
1 July 1989 in IEEE Transactions on Power Electronics
This paper presents a novel design of an active inductor based on the topology of Manetakis regulated cascode active inductor. The aim of this work is to enhance the manual design of active inductors by using AIDA-C design automation methodology. The circuit is manually designed using a 130 nm CMOS technology in Cadence® to obtain an Inductor operating at 14.2GHz. The sizing of the proposed active inductor has later been optimized using AIDA-C, a state-of-the-art multi-objective multi-constraint circuit-level optimization tool. The AIDA-C circuit sizing tool was able to achieve active inductor's solutions with higher quality factor, higher inductance at the operating frequency and also higher bandwidth than the manually designed solution, with the additional surplus of presenting a set of alternative Pareto optimal solutions that enables the designer to choose the most suitable circuit.
This paper deals with the improvement on low cost LTCC technology to achieve the specifications of planar filters for a 30GHz Satellite system transmitter. Test structures were fabricated on low cost LTCC technology, presently available for lower frequencies, to characterise its performances up to 40GHz. From this study, guidelines for the design of 30GHz circuits were obtained. Based on these results and their constraints, several solutions for a 30GHz transmitter filter were designed. A comparison between the LTCC filters with active and passive alternative solutions implemented on GaAs monolithic technology is also presented. The feasibility of millimeterwave filters on LTCC with a reasonable yield for mass production is demonstrated.