19 September 2012 in IEEE Transactions on Power Electronics
The Z-source inverter is a relatively recent converter topology that exhibits both voltage-buck and voltage-boost capability. The Z-source concept can be applied to all dc-to-ac, ac-to-dc, ac-to-ac, and dc-to-dc power conversion whether two-level or multilevel. However, multilevel converters offer many benefits for higher power applications. Previous publications have shown the control of a Z-source neutral point clamped inverter using the carrier-based modulation technique. This paper presents the control of a Z-source neutral point clamped inverter using the space vector modulation technique. This gives a number of benefits, both in terms of implementation and harmonic performance. The adopted approach enables the operation of the Z-source arrangement to be optimized and implemented digitally without introducing any extra commutations. The proposed techniques are demonstrated both in simulation and through experimental results from a prototype converter.
9 January 2024 in Journal of Electronics and Electrical Engineering
The particle swarm optimization (PSO) algorithm counts among the most popular metaheuristic algorithms based on swarm intelligence. Since the publication of the first article on this optimization technique, researchers have developed many PSO variants with some improvement in its performance. The PSO optimization performance hinges on its ability to achieve a good exploration-exploitation balance. The most common method that helps to improve exploration-exploitation balance is modifying the PSO three controlling parameters, namely the inertia weight and two acceleration coefficients. In this paper a PSO variant that combines adaptive dynamic inertia weight and adaptive dynamic acceleration coefficients to enhance the exploration-exploitation balance of the PSO is proposed. The enhanced PSO algorithm called Adaptive Dynamic Inertia Weight and Acceleration Coefficient Optimization (ADIWACO) algorithm is tested on seven well-known standard test functions comprising four unimodal and three multimodal ones. The performance of the PSO is then compared with that of the standard PSO (SPSO) and four existing PSO variants. The experimental results comprising optimum value, runtime, mean value, standard deviation and convergence rate, and confirmed by the results of ranking statistics and Wilcoxon signed rank test conducted on the experimental results, indicate significantly better performance by the proposed PSO algorithm.
1 February 2016 in IET Power Electronics
The ever increasing electric power demand and the advent of renewable energy sources have revived the interest in high‐voltage direct current (HVDC) multi‐terminal networks. However, the absence of a suitable circuit breaker (CB) or fault tolerant voltage source converter station topologies with the required characteristics (such as operating speed) have, until recently, been an obstacle in the development of large scale multi‐terminal networks for HVDC. This study presents a hybrid HVDC CB concept which is capable of meeting the requirements of HVDC networks. Simulation results are presented which are validated by experimental results taken from a 2.5 kV, 700 A rated laboratory prototype.
18 January 2020 in International Journal of RF and Microwave Computer-Aided Engineering
A circularly polarized printed antenna using an asymmetric open‐slot is designed in this paper. The presented antenna consists of conducting ground plane with open wide‐slot, fed electromagnetically by a microstrip feedline. The slot and feedline are positioned at the edge of the ground plane and substrate, hence making the antenna asymmetric. The measured results show that the |S11| < −10 dB impedance bandwidth is 125% (3.2‐14 GHz) and the broadband axial ratio bandwidth is 61% (3.2‐6 GHz). The antenna is very simple and has a small size of 25 mm × 25 mm, making it attractive for compact wireless WLAN, ISM, WiMAX, and C‐band applications.