Gunter Fischer

Gunter Fischer

Auto-generated profile, based on publicly available information

Gunter Fischer

IHP Microelectronics, Frankfurt Oder, Germany

Research Focus & Metrics

Academic Career Length

30Years (1997-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
27 September 2019 in IEEE Transactions on Microwave Theory and Techniques
Verified
Journal Article
Closed access
MEMohamed Hussein Eissa
Mohamed Hussein Eissa
NMNebojsa Maletic
Nebojsa Maletic
LLLukas Lopacinski
Lukas Lopacinski
AMAndrea Malignaggi
Andrea Malignaggi
GPGoran Panic
Goran Panic
DKDietmar Kissinger
Dietmar Kissinger
This article presents a fully integrated modular wideband frequency interleaving (FI) transmitter and receiver for high data rate communication applications. At the transmitter side, three independent in-phase and quadrature-phase (IQ) baseband channels are upconverted to different intermediate frequencies (IFs) and then interleaved. At the receiver side, the interleaved signals are downconverted and separated back to each independent channel. Single-ended inputs and outputs are utilized to reduce the pin count, for a more practical realization and higher potential toward future system scaling. Special design techniques are followed to minimize crosstalk and intermodulation products between the channels. All circuits are manufactured and measured in a 130-nm SiGe:C BiCMOS technology with fT,/,fmax,=,300/500 GHz. The FI transmitter achieves a channel bandwidth of 2.5 GHz with less than 3-dB difference across different channels until 15-GHz IF. It consumes 560 mW from 2.5 and 3.3 V supplies and occupies a silicon area of 1.9 mm². The FI receiver achieves a baseband channel bandwidth of 2.5 GHz with a 1-dB difference between the channels until the same IF. It consumes 860 mW from 2.5 and 3.3 V supplies and has a chip area of 1.55 mm². The circuits are deployed in a communication experiment; first, in a back-to-back test with a direct cable connection, demonstrating a data rate of 15.6 Gb/s across the three IQ channels with a 16-QAM modulation scheme and a worst case transmitter-to-receiver error vector magnitude (EVM) of -18.6 dB. Then, a wireless experiment is performed with a 240-GHz front end with on-chip antenna, demonstrating a data rate of 7.8 Gb/s with QPSK modulation and a worst case EVM of -8.3 dB, across a wireless link of 15 cm. To the best of our knowledge, this is the first article that demonstrates a wireless transmission at sub-terahertz (sub-THz) carrier frequencies utilizing FI architectures.

1 May 1997 in Journal of Applied Physics
Verified
Journal Article
Closed access
PDF file
PZP. Zaumseil
P. Zaumseil
GFG. G. Fischer
G. G. Fischer
KBK. Brunner
K. Brunner
KEK. Eberl
K. Eberl
The annealing behavior of pseudomorphic Si0.603 Ge 0.397 /Si and Si0.597 Ge 0.391 C0.012 /Si superlattice structures was studied in the temperature range between 750 °C and 900 °C. Carbon incorporation of 1.2% changes the thermal stability of SiGe structures significantly. It suppresses plastic relaxation due to an effective dislocation pinning. No relaxation of the SiGeC sample was observed during annealing up to 875 °C for 3 h. For comparison the SiGe sample relaxed at 800 °C. Carbon strongly increases the interdiffusion of Ge and Si. The activation energy of this diffusion process for a Ge content of 40% decreases from about 4.8 eV for the pure SiGe to about 2.0 eV with an additional C content of 1.2% assuming a neglectable diffusion of the carbon. This leads to a distinct modification of the Ge profile in the investigated temperature range.

15 June 2022 in IEEE Microwave and Wireless Components Letters
Verified
Journal Article
Closed access
EMEissa Mohamed
Eissa Mohamed
GFGunter Fischer
Gunter Fischer
TMThomas Mausolf
Thomas Mausolf
HRHolger Ruecker
Holger Ruecker
AMAndrea Malignaggi
Andrea Malignaggi
GKGerhard Kahmen
Gerhard Kahmen
A power combined wideband power amplifier (PA) covering the $J$ -band (220–320 GHz) is presented in 130-nm BiCMOS technology. The input power is split by two cascaded 1-to-2 power splitters with amplification stages in-between. The four split signals drive four output stages, which have their outputs combined within a 4-way zero-degree combiner. The splitting and combining networks also incorporate impedance matching. After de-embedding the I/O pads and baluns of 2 dB loss at each side, the PA achieves a gain of 20 dB at the middle of the band and a minimum gain of 17 dB at 320 GHz with I/O return losses below $-$ 5 dB. The PA records a saturated output power ranging from 9.5 to 14.5 dBm across the $J$ -band. It consumes 710 mW from a 3 V supply which corresponds to a drain efficiency ( $\eta_d$ ) of 3.15% at 270 GHz. The presented PA achieves twice better bandwidth with 1.5 times better $\eta_d$ than the state-of-the-art silicon-based amplifiers above 200 GHz. To the authors’ knowledge, this is the first PA covering the whole $J$ -band in silicon technologies.

1 September 2010
Verified
Conference Paper
Closed access
GFGunter Fischer
Gunter Fischer
OKOleksiy V Klymenko
Oleksiy V Klymenko
DMDenys Martynenko
Denys Martynenko
HLHeinz Luediger
Heinz Luediger
This paper describes a monolithic integrated transceiver chipset intended for impulse radio (IR) Ultra-wide band (UWB) applications including indoor communication and indoor localization. The chipset operates in the higher UWB band centered at 7.68 GHz and it is optimized for a pulse bandwidth of about 1.5 GHz. The average pulse repetition rate of 60 MHz and an octagonal pulse position modulation (8-PPM) allow for raw data rates up to 180 MBit/sec. The available high bandwidth is used for precise indoor localization employing a dedicated time-of-arrival (TOA) measurement extension. This unit runs with an on-chip system clock of 3.84 GHz, which allows a measurement accuracy of 260 picoseconds. As demonstrated this UWB transceiver chipset is well suited for two-way ranging (TWR) in potentially harsh RF propagation environments. Under perfect line-of-sight conditions a spatial resolution of about 3.9 centimeter could be achieved.

1 September 2008
Verified
Conference Paper
Closed access
SOS. Olonbayar
S. Olonbayar
GFG. Fischer
G. Fischer
RKR. Kraemer
R. Kraemer
Ultra Wideband (UWB) has been gaining growing research and industry interests in many different areas of wireless communications. Among them using UWB as a radio interface for wireless sensor network is of high interest due to its precise localisation and low power consuming capabilities. In this paper we carry out quantitative analysis into the synchronisation performance of UWB when it operates under usual wireless channel environments. Simulation results confirm that coherent receiver needs around 10 dB less signal to noise ratio to achieve synchronisation compared to the noncoherent detection. Higher spreading factors lead to noticeable improvement for both coherent and noncoherent detection.

1 October 2018
Verified
Conference Paper
Closed access
POP. Ostrovskyy
P. Ostrovskyy
OSO. Schrape
O. Schrape
KTK. Tittelbach-Helmrich
K. Tittelbach-Helmrich
FHF. Herzel
F. Herzel
GFG. Fischer
G. Fischer
DKD. Kissinger
D. Kissinger
This paper describes a radiation hardening design approach of a dual channel 16 GSps single chip arbitrary waveform generator (AWG) - a complex mixed-signal ASIC - that consists of a low phase noise 16 GHz PLL, two 1.6 Mbit SRAM blocks, two multiplexing chains, and two 4-bit DACs. The ASIC is dedicated to be a part of a submillimeter wave spectrometer that shall operate in deep-space environment. Under stringent power budget conditions, a selective radiation protection of the ASIC has been applied. The arbitrary waveform generator has been fabricated in a 130 nm SiGe BiCMOS process. Correct functionality has been verified in lab and will be further tested in an irradiation facility.