Xinbo Hu

Xinbo Hu

Auto-generated profile, based on publicly available information

Xinbo Hu

Southwestern Institute of Physics, Chengdu, China

Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
12 August 2020 in Superconductor Science and Technology
Verified
Journal Article
Closed access
XHXinbo Hu
Xinbo Hu
MSMichael Small
Michael Small
KKKwanglok Kim
Kwanglok Kim
KKKwangmin Kim
Kwangmin Kim
KBKabindra Bhattarai
Kabindra Bhattarai
DLDavid Larbalestier
David Larbalestier
REBCO coated conductors are now being used for building very high-field magnets with large electromagnetic stresses, both expected ones due to transport current J ⃗ × B ⃗ stresses and additional stresses resulting from the large screening currents inherent in wide tapes. Post mortem analyses of several recent test coils operated above 40 T show that significant conductor plastic deformation occurs, even for JBR stresses well below the ∼1 GPa yield of the Hastelloy substrate of the conductor. To investigate these deformation mechanisms, conductors were unwound after coil test and carefully examined with respect to their length-wise I c which revealed many areas of local damage. Regions of interest were examined by metallographic cross-section, Hall microscopy, magneto-optic imaging and scanning electronic microscopy. Important damage frequently occurred to the outer edges of pancakes in the coil ends, which were often plastically deformed over the whole turn circumference, especially when this outer edge was a slit edge. Internal conductor damage was also seen, especially delamination between the buffer and REBCO layers at slit edges. Careful sectioning of the tape at ∼10 mm intervals showed that the plastic deformation of the turns was complex and variable around the turn circumference, with tape cross-sections that exhibited continuous shape change in the outer turns. The bending center line of tapes often shifted from the tape center line toward the edge closest to the coil center, indicating asymmetric effects of transport and screening current stresses across the conductor width. A surprising and vital result is that damage was prevalent when the slit edge was also the edge at which transport current flowed. This damage was absent when the transport current flowed at the not-slit edge, implying great sensitivity of the effect of screening current stresses to localized conductor damage.

28 June 2024 in IEEE Transactions on Applied Superconductivity
Verified
Journal Article
Closed access
YZYunpeng Zhu
Yunpeng Zhu
ZYZongyu Yang
Zongyu Yang
Xinsheng YangXinsheng Yang
Xinsheng Yang
XHXinbo Hu
Xinbo Hu
JLJian Liu
Jian Liu
YZYong Zhang
Yong Zhang
The AC loss of the high temperature superconducting (HTS) cable with joints is a key factor to estimate the cooling effect of the HTS cable. In this work, an artificial intelligence-based model is proposed to predict the AC loss of REBCO lap joints when carrying alternating current. The training data was obtained from simulation by a 3-D lap joint model based on H-formulation. The artificial intelligence-based model is demonstrated to evaluate the effect of inhomogeneity of joint resistance on AC loss. It is shown that the AC loss of lap joints in the cable is increased when the nonuniformity of joint resistance is higher. The proposed model can increase the speed of calculating the statistical results depending on the mass of investigating data.

18 September 2024 in IEEE Transactions on Applied Superconductivity
Verified
Journal Article
Closed access
TQTian Qiu
Tian Qiu
YZYunpeng Zhu
Yunpeng Zhu
Xinsheng YangXinsheng Yang
Xinsheng Yang
XHXinbo Hu
Xinbo Hu
JLJian Liu
Jian Liu
YZYong Zhang
Yong Zhang
Quench propagation characteristics are the key issue for high temperature superconductor (HTS) cables and magnets. In this work, the effect of magnetic field on minimum quench energy (MQE) and the normal zone propagation velocity (NZPV) of two types of HTS tapes, including Bi-2223 and REBCO, are studied by experimental method in 77 K, respectively. The equivalent heat capacity of the two tapes was used to evaluate the MQE property. The experimental results show that the MQE of HTS tape is sensitive to the magnetic field, whereas the NZPV of HTS tape shows less sensitivity to the magnetic field. Although the volume heat capacity of REBCO tape and Bi-2223 tape is similar, the equivalent heat capacity of samples shows a higher difference and leads to the lower MQE for REBCO tape. It is also shown that the NZPV of Bi-2223 tape is smaller than that of REBCO tape.

27 June 2024 in IEEE Transactions on Applied Superconductivity
Verified
Journal Article
Closed access
YZYunpeng Zhu
Yunpeng Zhu
SGShuyang Gao
Shuyang Gao
Xinsheng YangXinsheng Yang
Xinsheng Yang
XHXinbo Hu
Xinbo Hu
JLJian Liu
Jian Liu
YZYong Zhang
Yong Zhang
In This work, two types of Bi-2223 stacked tape cables, including stacked tape stand and 6-slot HTS Cable-in-conduit-conductors (CICC), are prepared. The magnetization loss of cables is measured at liquid nitrogen with the amplitude sinusoidal modulated magnetic field varies from 200 Gs to 1600 Gs and the frequency of 23.5 Hz. The effect of different arrangement of strands, various angles of applied magnetic field and different type of frame on total AC loss are studied, respectively. The result shows that the AC loss of triplet strand with surround type is lower than that with parallel type. For the HTS CICC, the total AC loss is also decreased when the magnetic field is not perpendicular to the wide side of tape. The hysteresis loss is considered as the main reason for the difference value of total AC loss under various angle of applied field. The total AC loss of CICC with copper frame is much higher than that with aluminum frame due to larger eddy current loss. Moreover, the shape of the frame also has a great influence on the eddy current loss where the total AC loss of CICC with split frame is significantly reduced compared with the origin frame.

29 July 2024 in IEEE Transactions on Applied Superconductivity
Verified
Journal Article
Closed access
RWRun Wu
Run Wu
XHXinbo Hu
Xinbo Hu
XLXiaoqiang Lai
Xiaoqiang Lai
LCLijun Cai
Lijun Cai
Bending stresses in winding magnets cause the degradation of the performance of HTS conductors. Here, we tested the critical currents ( Ic ) of a Bi2223 stacked-tape cable under bending and analyzed the stress distribution and the Ic of the cable under bending by finite elements method (FEM). Then we analyzed the Ic of the stacked-tape CICC conductor under bending. The experimental results show that the critical bending radius ( rc ) of the cable is about 0.25 m, which is similar to the results of FEM. The rc of the CICC conductor is about 2.4 m and the 4-slots CICC conductor has the smallest rc at the bending angle of 45°.

1 November 2026 in IEEE Transactions on Applied Superconductivity
Verified
Journal Article
Closed access
RSRui Shen
Rui Shen
JJJing Jiang
Jing Jiang
Xinsheng YangXinsheng Yang
Xinsheng Yang
XGXubo Gao
Xubo Gao
YZYunpeng Zhu
Yunpeng Zhu
XHXinbo Hu
Xinbo Hu
Bi-2223 high-temperature superconducting (HTS) tapes, with their relatively high upper critical field and current-carrying capability, the fine multi-filamentary microstructure, the excellent thermal stability under high magnetic fields and mature manufacturing processes, exhibit significant application potential in large-scale high-field magnets. The current distribution among Bi-2223 stacked tapes is a critical factor governing the stable operation of Bi-2223 stacked-tape cables. In this work, a five-layer Bi-2223 stacked-tape cable sample was investigated using an integrated measurement–inversion–simulation–validation approach, with a focus on the influence of joint resistance non-uniformity on the current distribution in multi-tape stacked cables. An annular Hall sensor array was employed to measure the circumferential magnetic field response of a short stacked-tape cable sample, and the current redistribution within the cable was identified and tracked through features of the derivatives of the magnetic field as a function of current. Taking account of the strongly nonlinear E–J characteristics and the anisotropy of the critical current density of the superconducting material, a two-dimensional finite element method (FEM) based on the H-formulation coupled with an equivalent circuit model (ECM) was used to investigate the effects of the non-uniformity of the joint resistance on the internal current distribution at different current ramping rates. A good agreement between experimental measurements and numerical simulations was obtained. The results provide experimental and theoretical support for joint resistance optimization, uniform current sharing, and current redistribution monitoring in HTS cables, and offer guidance for improving the current-carrying performance and operational stability of HTS stacked-tape cables for large-scale high-field magnets.