1 December 2021 in Letters on Materials
The effect of a treatment combining isothermal cryogenic rolling and single electro-pulsing on the structure and hardness of M1 grade copper with an initial grain size of 10 –15 μm was investigated.
19 December 2025 in Facta Universitatis, Series: Mechanical Engineering
A synergy effect of cryorolling and high-dense electric pulsing on the structure, texture and hardness of fine-grain Cu is analyzed. More than twice Cu strengthening under rolling with 90% reduction at –196°С was caused by strong rolling texture and work-hardened nanostructure with ~300 nm crystallites and ~30% fraction of high-angle boundaries. Further single pulsing with current intensity Kj = 3.5×104 A2s/mm4 resulted in a static recovery and slight Cu softening due to the formation of a more equilibrium structure with lower dislocation density and lattice microstrain. Increasing Kj to 3.8×104 A2s/mm4 led to a sharp drop in the Cu hardness owing to continuous recrystallization and texture randomization. At Kj near 5.0×104 A2s/mm4 homogeneous ultrafine-grain structure with 1 μm defect free equiaxed grains and about 30% of twin boundaries is formed. Normal grain growth to 3 µm and gradual decrease of the Cu hardness were taking place at higher pulsing energies, up to 8.1×104 A2s/mm4.
1 January 2023 in Frontier materials & technologies
IRInstitute for Metals Superplasticity Problems of RAS
Institute for Metals Superplasticity Problems of RAS
ЕАЕлена Викторовна Автократова
Елена Викторовна Автократова
АВАйгуль Хамматовна Валеева
Айгуль Хамматовна Валеева
+4
The data of a comparative analysis of the structure and hardness of pure metals with a face-centered cubic lattice – aluminum, nickel and copper, subjected to complex thermomechanical treatment (TMT), including isothermal cryogenic rolling at liquid nitrogen temperature and subsequent high-density electropulse treatment (EPT) were presented. The main stages, features and advantages of TMT, which first ensure strong work hardening of the processed material due to deformation at low temperatures and then its ultra-fast contact electropulse heating up to a specified temperature, were considered. A multi-level analysis of the metals structure evolution due to TMT was carried out using modern methods of scanning electron microscopy and X-ray diffractometry, recording a wide range of its linear and angular parameters. The kinetics and nature of the processes of the metals structure evolution under cryogenic rolling and EPT, their driving forces and controlling factors, as well as general patterns and temperature intervals of activation of the deformation structure recovery and recrystallization influenced by an electric pulse are identified and discussed. Based on the results of the analysis of the structural and mechanical behaviour of metals, it was concluded that the combination of severe plastic cryogenic deformation and a single-step treatment with ultrashort alternating current pulses is an effective way to obtain semi-finished products with controlled parameters of their structure and properties, including high-strength ultrafine-grain rolled products. At that the phenomenology and nature of the strengthening/softening of metals during cryogenic rolling and subsequent electropulsing are similar to those observed under cold rolling and furnace annealing.