12 February 2021 in Journal of Physics D: Applied Physics
This paper presents the results of studying dispersed media formation during the electrical explosion of thin metal wires in vacuum by using low-current generators (∼1–10 kA). Particular attention is paid to the analysis of the composition and structure of the corresponding explosion products as well as to the problem of their visualization using simultaneous laser interferometry and shadow imaging at two wavelengths (1.064 µ m and 0.532 µ m). Our findings indicate the important role in the visualization of the explosion products that belongs to multiple scattering by submicron droplets of dense condensed matter, which are mixed with metal vapor. The hypothesis on the existence of submicron droplets in the products of exploding metal wires correlates with the results obtained by soft x-ray radiography combined with a laser probing technique. Taking into account the multiple scattering by submicron droplets, it is possible to significantly clarify the parameters of the explosion products visualized via laser probing techniques as well as to gain a deeper insight into the physics behind the electrical wire explosion.
25 November 2020 in Journal of Applied Physics
We have investigated the features produced in flat metal foils as a result of nanosecond explosions and phase transitions at current densities of (0.1–2) ⋅ 109 A/cm2. Thin foils made of aluminum, copper, nickel, and titanium, with thicknesses of 1–15 μm, were tested. The exploded foil structure was studied using X-pinch radiography and laser shadow imaging. Al, Ti, and Cu (5 and 7 μm thick) foils had an initial two-dimensional structure. At the same time, no apparent structure was registered in 1 μm Cu and 5 μm Ni foils. Experiments on generators with different output parameters have shown that the dominant structures that developed in the explosion are either cracks or bubbles and may depend on the orientation of the initial structure in the thin foil with respect to the current direction. In addition, the energy deposited in the foil differs by a factor of about 1.5 for the orthogonal vs parallel current and initial foil structure directions.
1 April 2017 in Journal of Experimental and Theoretical Physics
The prebreakdown stage of a gas discharge in a diode with strongly overloaded cathode is studied by laser methods (by simultaneous use of multiframe interferometry and shadow and schlieren photographing) at atmospheric pressure. The spatial resolution of the methods is about 20 μm. A probing pulse of a laser (LS-2151 Nd: YAG laser with a half amplitude duration of 70 ps and a pulse energy of up to 40 mJ) is synchronized with a voltage pulse with accuracy of about 1 ns. High field strength at the cathode is achieved due to the use of thin individual metal tips on the electrodes. It is shown that the initial stage of breakdown of a discharge gap is accompanied by the emergence of a dense plasma cloud at the end of a tip with electron density of about 5 × 1019 cm–3 with a size of tens of microns, as well as by a sharp increase in the total current through the diode. After the emergence of a dense plasma cloud at the end of a cathode tip, a similar cloud is formed on the surface of the anode; sometime later, these clouds join together and form a tubular current channel. The dynamics of the breakdown, as well as the parameters of the plasma are studied by the abovementioned techniques in three independent optical channels.
31 January 1995 in Quantum Electronics
25 September 2006 in Review of Scientific Instruments
A new configuration for a two-dimensional (2D) imaging x-ray spectrograph based on a conically bent crystal is introduced: extreme luminosity imaging conical spectrograph (ELICS). The ELICS configuration has important advantages over spectrographs that are based on cylindrically and spherically bent crystals. The main advantages are that a wide variety of large-aperture crystals can be used, and any desired magnification in the spatial direction (the direction orthogonal to spectral dispersion) can be achieved by the use of different experimental arrangements. The ELICS can be set up so that the detector plane is almost perpendicular to the incident rays, a good configuration for time-resolved spectroscopy. ELICSs with mica crystals of aperture have been successfully used for imaging on the XP and COBRA pulsed power generators, yielding spectra with spatial resolution in 2D of pinches and pinches.
1 October 2004 in Review of Scientific Instruments
We present diagnostic images taken of an -pinch plasma x-ray source driven by the XP pulser at Cornell University using an x-ray bubble compound refractive lens. The lens consists of a inside diameter glass capillary that contains about biconcave microlenses formed by a string of bubbles in epoxy. A precise system for lens alignment with of 3–5 arcmin accuracy is described. X-ray images of four-wire pinches were obtained with a spatial resolution of approximately .