13 November 2016 in Journal of Composite Materials
The electrical conductivity of carbon nanotube–epoxy composites is investigated analytically and experimentally. The theoretical predictions of the effective electrical conductivity of carbon nanotube–epoxy composites were performed by the analytical approach based on a micromechanical model of composites. The parametric analysis carried out revealed an influence of geometrical and electrical parameters of the micromechanical model on the effective electrical conductivity of carbon nanotube–epoxy nanocomposite. The nanocomposites made from the DGEBA-based and RTM6 epoxy resins filled with different weight content of Baytubes C150P and N7000 multi-walled carbon nanotubes were prepared. The experimental values of the electrical conductivity of the nanocomposites were compared with those calculated by means of the analytical model.
26 April 2018 in Proceedings of the Estonian Academy of Sciences
In recent years, research in the field of insulation materials in buildings has been focusing increasingly more upon ecological properties of these materials. Hemp is an annual bast fibre plant, which delivers fibres, shives, and seeds. Bast fibres are used as a raw material for thermal insulations while shives have been mainly used in animal bedding and construction. The aim of this research was to evaluate the mechanical and physical properties of the industrial hemp fibre- and bast-based insulation materials and compare them with wood-based materials. For producing hemp fibreboards, the hemp shives were ground with separative milling by a semi-industrial disintegrator to the average particle size of 0.136Â mm. Ureaâformaldehyde (UF) resin was used as the adhesive for hemp particleboards and fibreboards made by the dry method. Fibreboards made by the wet method were bonded without using any binders. Some fibreboards made by the dry method were covered with kraft paper on both sides using UF resin and PVA glue. Properties of particleboards and fibreboards were tested with the determination of density, swelling, resistance to axial withdrawal of screws, tensile strength perpendicular to the plane of the board, bending strength, and air permeability. The results showed that fibreboards made by the dry method were stronger and tougher than fibreboards made by the wet method. The only shortcoming of the former was their low water resistance as samples dissolved in water. Hemp particleboards were lighter and less dense than wood particleboards. However, the mechanical properties of the hemp particleboards were inferior to those of wood particleboards. In addition, the levels of water absorption and swelling of the hemp particleboards were higher than those of the wood particleboards.
1 June 2019 in IOP Conference Series: Earth and Environmental Science
The use of timber with other bio-based building materials is often restricted due to the fire hazard. The primary protection for timber against fire is provided by cladding. Currently, there is limited fire protection design data on clay and hemp boards since they are relatively new products. Furthermore, the mechanical performance of boards is of utmost importance in timber frame assemblies. This paper presents a test program that determines the tensile and bending strength of boards accompanied by a comparison to widely used gypsum plasterboards. The fire protection effect for timber is assessed by using a cone heater. Main results indicate that clay and hemp boards are adequate alternatives for the gypsum plasterboards as they can demonstrate similar performance. Hemp boards made by dry method perform significantly better compared to the ones made by wet method. Clay boards with special additive demonstrate increased fire performance compared to more ecological boards. This study contributes to further research that is needed in order to provide design parameters for sustainable building solutions in the future.