Anne Berger

Anne Berger

Auto-generated profile, based on publicly available information

Anne Berger

Technical University of Munich; TUM School of Natural Sciences, Department of Chemistry and Catalysis Research Center, Chair of Technical Electrochemistry, Garching, Germany

Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 September 2023 in Journal of the Electrochemical Society
Verified
Journal Article
Open access
ABAnne Berger
Anne Berger
YCYen-Chun Chen
Yen-Chun Chen
JGJacqueline Gatzemeier
Jacqueline Gatzemeier
TSThomas J. Schmidt
Thomas J. Schmidt
FBFelix N. Büchi
Felix N. Büchi
HGHubert A. Gasteiger
Hubert A. Gasteiger
Interfaces are crucial for the water management in polymer electrolyte membrane fuel cells (PEMFCs). The introduction of a microporous layer (MPL) had a revolutionary effect on the water distribution by improving the interface between the catalyst layer and the gas diffusion layer substrate (GDL-S). Hence, it is vital to maximize the improvement by further characterizing and advancing the properties of the interfaces, in this case the MPL/GDL-S interface. This study aims at fabricating a GDL with an MPL that intrudes into the GDL-S, analyzing the impact on the GDL-S structure and on PEMFC performance. Mercury intrusion porosimetry (MIP) and ex situ X-ray tomography (XTM) show that the intrusion of the MPL into the hydrophobic GDL-S proceeds via the preferential filling of the GDL-S macropores, thereby reducing their size and volume fraction in the GDL-S. While an intruding MPL leads to a small performance increase under wet PEMFC operating conditions, this improvement could only be achieved by a careful management between the extent of MPL intrusion and the partial macropore blocking in the GDL-S. Furthermore, the impact of MPL intrusion on the liquid water saturation of the GDL was quantified by operando XTM. The results provide design guidelines for improved GDLs.

1 May 2018 in Journal of the Electrochemical Society
Verified
Journal Article
Open access
PDF file
ABAnne Berger
Anne Berger
AFAnna T. S. Freiberg
Anna T. S. Freiberg
ASArmin Siebel
Armin Siebel
RTRowena Thomas
Rowena Thomas
MPManu U. M. Patel
Manu U. M. Patel
YGYelena Gorlin
Yelena Gorlin
The underlying mechanism of lithium-sulfur batteries is still not fully established because it involves a series of both chemical and electrochemical reactions as well as the formation of soluble polysulfide intermediates. To improve the mechanistic understanding of lithium-sulfur batteries, this study investigates chemical reactions between the Li2S cathode and more oxidized sulfur species, such as S8 and polysulfides, during the electrochemical charge of the battery. By combining the electrochemistry with X-ray absorption spectroscopy, we show that chemical reactions and, in particular, the resulting accumulation of solution species in the electrolyte are essential to oxidize Li2S at a low overpotential. Additionally, by efficiently separating the anode and cathode compartments of a battery with a lithium ion-exchanged Nafion interlayer, we establish the adverse effect of the anode on the buildup of solution intermediates. In the absence of the interlayer, polysulfide intermediates can diffuse through the separator and react at the anode's surface, while the addition of the interlayer allows the intermediates to accumulate in the separator of the cathode compartment and facilitate the oxidation of Li2S.

13 January 2023 in Chemical Engineering Journal
Verified
Journal Article
Closed access
HBHanh My Bui
Hanh My Bui
PGPaula F. Großmann
Paula F. Großmann
ABAnne Berger
Anne Berger
ASAlexander Seidel
Alexander Seidel
MTMarkus Tonigold
Markus Tonigold
KHKai-Olaf Hinrichsen
Kai-Olaf Hinrichsen

1 July 2023 in Journal of the Electrochemical Society
Verified
Journal Article
Open access
SÜSeçil Ünsal
Seçil Ünsal
MBMichele Bozzetti
Michele Bozzetti
YCYen-Chun Chen
Yen-Chun Chen
RGRobin Girod
Robin Girod
ABAnne Berger
Anne Berger
Juan HerranzJuan Herranz
Juan Herranz
Non-noble metal catalysts (NNMCs) are regarded as a promising alternative to the costly Pt-based materials required to catalyze the oxygen reduction reaction (ORR) in proton exchange membrane fuel cell (PEMFC) cathodes. However, the large diversity of NNMC synthesis approaches reported in the literature results in materials featuring a wide variety of particle sizes and morphologies, and the effect of these properties on these catalysts’ PEMFC performance remains poorly understood. To shed light on this matter, in this work we studied the physical and electrochemical properties of NNMC layers prepared from materials featuring broadly different aggregate sizes, whereby this property was tuned by ball milling the precursors used in the NNMCs’ synthesis in the absence vs presence of a solvent. This led to two NNMCs featuring similar Fe-speciations and ORR-activities, but with vastly different aggregate sizes of >5 μm vs ≈100 nm, respectively. Following the extensive characterization of catalyst layers (CLs) prepared with these materials via electron microscopy and X-ray tomography, PEMFC tests at different loadings unveiled that the smaller aggregate size and ≈20% higher porosity of the CL prepared from the wet-milled sample resulted in an improvement of its mass transport properties (as well as a ≈2-fold enhancement of its peak power density under H2/air operation) over the dry-milled material.

1 June 2025 in Journal of the Electrochemical Society
Verified
Journal Article
Open access
LRLeonhard J. Reinschlüssel
Leonhard J. Reinschlüssel
LRLennart Reuter
Lennart Reuter
PRPhilip Rapp
Philip Rapp
MBMoritz Bock
Moritz Bock
ABAnne Berger
Anne Berger
HGHubert A. Gasteiger
Hubert A. Gasteiger
Operating lithium-ion batteries (LIBs) to high charging cut-off potentials allows us to accommodate a further push in energy density. However, it requires a thorough understanding of the interplay and temperature dependence of parasitic reactions that aggravate the aging of the electrolyte and the cathode/anode electrodes. In the present study we investigated the interplay of the chemical and the electrochemical electrolyte oxidation, how they are related to the dissolution of transition metal (TM) ions from the cathode active material (CAM), and how they shift or accelerate with temperature. Through an optimized electrochemical protocol an excellent potential dependence of the gas evolution of a LiNi0.80Co0.15Al0.05O2 (NCA) charged against a free-standing graphite on a lithium metal electrode in a LP47 electrolyte was achieved. We identified O2 and PF5 gas as suitable proxies for the chemical and electrochemical electrolyte oxidation, respectively. Both processes are separated by at least 300 mV over a temperature range from 10 to 45 °C. Through temperature-dependent operando hard X-ray absorption spectroscopy measurements and their comparison with the gassing results, it will be shown, that the electrochemical oxidation of the electrolyte is directly linked to the dissolution of TMs, while the chemical electrolyte oxidation mainly leaves the transition metal dissolution unaffected.

1 January 2025 in Journal of the Electrochemical Society
Verified
Journal Article
Open access
ABAnne Berger
Anne Berger
MSMichael Striednig
Michael Striednig
CSChristoph Simon
Christoph Simon
HGHubert A. Gasteiger
Hubert A. Gasteiger
An understanding of the GDL properties is crucial for high-current-density operation of proton exchange membrane fuel cells (PEMFCs). The parameters porosity ( ε ) and tortuosity ( τ ) directly link the theoretical diffusivity in free space and the effective diffusivity in the structure. The τ / ε -ratio is therefore an important descriptor for the gas diffusion in a porous network. This study characterizes the τ / ε -ratio for gas diffusion layer substrate (GDL-S) materials from two suppliers (Toray, Freudenberg) and for one microporous layer (MPL) using limiting current measurements in an operating fuel cell. However, only the application of a new analysis method that considers the contribution from Knudsen diffusion allows for the τ / ε -determination of GDL-S materials which have carbon black added to the structure (e.g., Freudenberg GDL-S); this method can then also be used for the determination of the τ / ε -ratio of porous networks containing small pores like MPLs. Here, we assess the contribution of pressure-independent Knudsen diffusion to the overall diffusion and introduce a mixed diffusion coefficient, which includes both Knudsen and molecular diffusion. This analysis serves as a guideline to estimate the contribution of the respective diffusive processes for gas diffusion materials utilized in PEMFCs, where pore sizes resulting in different diffusion regimes are present.