This paper focuses on developing power management strategies for hybrid energy storage systems (HESSs) combining batteries and supercapacitors (SCs) with photovoltaic (PV) systems. The proposed control scheme is based on proportional‐integral (PI) controllers optimized with particle swarm optimization (PSO) and duplicate particle swarm optimization (DPSO) algorithms. The aim is to reduce peak current and the energy management system’s response time while enhancing the system’s stability during the charging and discharging of the HSS under various operating conditions. A comparative study with other tuning methods is presented to demonstrate the effectiveness of the proposed DPSO algorithm in particle duplication, population diversity, and the convergence speed toward the global optimum, enhancing the overall system’s performance. The results demonstrate the feasibility and robustness of the PI − DPSO in providing quick and accurate responses even under variable load, variable solar irradiations, and variable temperature, thus enhancing the dynamic response of the SC and reducing battery stress, resulting in a longer lifespan for the HESS.
25 October 2019 in International Journal of System Assurance Engineering and Management
One of the main issues with grid-connected distributed energy systems, including photovoltaic (PV) systems, is the DC bus voltage's instability during load fluctuations and power line short circuits. This paper attempts to address this problem and proposes to use superconducting magnetic energy storage (SMES) to stabilize the voltage of the DC link and improve the power quality and transient stability of the power system. The investigated configuration components are PV cells, boost converter, chopper, SMES, three level inverter (NPC), filter, grid, and load. MATLAB / Sim Power System is used to test the performance of a SMES in order to ensure the balance of the DC bus voltage of a PV system connected to the grid. Several scenarios were considered to show the performance and benefits of combining a SMES with the PV system. The outcomes of the examined scenarios (fault and load change) demonstrate the precision of the employed control systems, maintaining the DC voltage at acceptable levels (≈500 V), enhances the structure stability, and improving power quality (GPV THD = 4.34). Finally, it can be concluded that the proposed configuration will help in achieving high penetration scenarios of PV systems.
1 December 2013 in International Journal of Power Electronics and Drive Systems (IJPEDS)
This article proposes hierarchical power management and energy control aimed at improving the reliability and efficiency of electric power generation from a wind farm connected to the grid. The wind farm consists of three wind energy conversion systems (WECS) each consisting of a wind turbine, a double‐feed induction generator and five‐level power converters. The first control layer includes a maximum power point tracking algorithm to extract the maximum power from the wind energy source based on an optimal torque control strategy. The real and reactive power flow from the WECS to the grid is controlled with a non‐linear backstepping controller based on the Lyapunov stability theory. Finally, a DC bus voltage controller with a clamping bridge is employed to ensure the stability of the DC bus voltage and to compensate for transient disturbances caused by load fluctuations. The second layer of control ensures coordination between the wind farm, the power grid and the load to ensure reliable and efficient power supply. The model of the grid‐connected wind farm and the proposed control scheme are developed using MATLAB and Sim Power Systems Toolbox. A series of simulation scenarios are presented to evaluate the performance of the proposed control scheme under various operating conditions.