1 June 2009 in Fusion Engineering and Design
1 December 2002 in Fusion Engineering and Design
27 April 2023 in Journal of Vacuum Science & Technology B
An improvement for the vacuum system of the multidriver radio frequency (RF) prototype negative ion source SPIDER has been developed, to allow operating at high RF power, while minimizing the breakdown probability on the outside of the plasma source. A first-of-its-kind large nonevaporable getter (NEG) pump, based on a modular design of 384 cartridges totaling about 350 kg of ZAO® alloy (composed by Zr-Ti-V-Al) with an installed pumping speed at a room temperature of 330 m3/s for hydrogen, will complement the existing pumping system, based on eight cryogenic pumps and four turbomolecular pumps totaling about 90 m3/s in hydrogen. The vessel pressure during absorption is expected to be between 20 and 40 mPa, while during the getter regeneration, the peak operating pressure will be around 2 Pa. The NEG pump will use an additional vessel module, with integrated thermal shields to protect the in-vessel components during activation and regeneration of the pump, to be carried out at temperatures in the range of 550–600 °C. Integrated thermal analyses were carried out to verify the low heat load on pre-existing in-vessel components with a low limit of acceptable temperature, and to provide boundary conditions for the mechanical verifications of the pump structure. The scenario of cyclic hydrogen load was calculated considering the SPIDER operation modes, the expected gas throughput, and the cumulated load to the pump, to determine the regeneration temperature and auxiliary pumping necessary to make the regeneration duration compatible with the high availability of the system. The upgrade of the auxiliary pumping system is also described, as well as the mitigation of air or water exposure risk during regeneration of the NEG pump.
1 September 2019 in Fusion Engineering and Design
9 March 2018 in IEEE Transactions on Plasma Science
Heating and current drive (H&CD) systems are being investigated for a demonstration fusion power plant DEMO to deliver net electricity for the grid around 2050. Compared to ITER, which has to show the generation of 500-MW thermal power, the target of DEMO is the successful production of 300 to 500 MW electrical power to the grid and to aim for a self-sufficient tritium fuel cycle. Three H&CD systems are under development for DEMO in Europe, the electron cyclotron (EC) system, the neutral beam injection (NBI) system, and the ion cyclotron system. Based on present studies for plasma ramp-up, ramp-down, and flat top phases, to be further validated in more detailed simulations, the assumed total launched power needed from the H&CD system in DEMO is in the range of 50-100 MW, to be provided for plasma heating and control. This paper describes the design and Research and Development status of selected H&CD systems, considered for their deployment in the EU DEMO. It was always considered that different H&CD configurations and design variants will have an impact on the performances for the whole fusion plant. It shall be noted that the basis for the H&CD integrated design and system development is the actual version of the European fusion electricity roadmap. The project also elaborates on H&CD efficiency improvements which will reduce the recirculating power fraction in the future fusion power plants. Different studies under investigation will be discussed such as for NBI the photoneutralization and for EC novel concepts for gyrotron multistage-depressed collector.