27 April 2023 in Frontiers in Materials
Thermoplastic Composites can be re-melted allowing them to be joined via welding. This is an attractive alternative to conventional methods that are used to join thermoset composite parts such as mechanical fastening and adhesive bonding. In this work the inductive heating of uni-directional (UD) plies of thermoplastic carbon fiber reinforced polymer (CFRP) laminates is investigated. The focus is on developing a numerical electromagnetic and thermal simulation model that captures the main processes involved in eddy current generation and heat generation, in particular in the interface areas of the UD plies. A measurement technique has been developed to obtain the electric properties of the ply material. Furthermore, to support the modelling of both the induction heating equipment and work piece a field measurement of the magnetic field surrounding the coil and work piece has been developed. Inductive heating experiments were carried out on several thick composite laminate plates with different ply lay-ups to compare and validate the electro-magnetic-thermal simulation model. The measured surface temperatures were compared with the results from the simulation model. The results of this work can be used to support the design of UD-ply laminates to improve their ability to be welded via inductive heating. In addition, the results of this work can be used to assist in pre-determining induction welding equipment settings and heating times.
3 March 2022 in The Aeronautical Journal
Unmanned Aerial Systems (UASs) are increasingly starting to dominate the lower airspace. This increases the chance that a UAS will hit the means of transport of people e.g. aircraft, helicopters. For air traffic, the European Union Aviation Safety Agency (EASA) and the Federal Aviation Administration (FAA) are in the process of determining the threat of a UAS impact on aircraft. This will result in new rules that may impose new, or additional, requirements on the ‘wetted zones’ of aircraft and the like. Current research suggests that aircraft wetted-areas (e.g. wing leading edge) that are certified for so called ‘bird-impact’ may not sustain a ‘UAS-impact’, such an UAS-impact may even damage the primary load carrying structure. But what would happen if multiple UASs are flying close to one other? To the authors’ knowledge, the damage caused by multiple UAS impacts on a wetted surface zone has not yet been established.A finite element modelling approach is chosen for the UAS; specifically, a Lagrangian approach is applied using material nonlinearity and damage. A comparison is made between the damage caused by a bird impactor and a UAS impactor model. To establish the resulting damage of multiple UAS impacts on a wing leading edge, a multiple-UAS impact scenario is executed. The results show that a wing leading edge capable of sustaining a bird impact may not be capable of sustaining a UAS impact, which supports previous findings. Furthermore, for all simulated cases the front spar was not penetrated by components that managed to enter the leading edge. However, for the heavier drone some deformation of the front spar was observed. The multiple UAS impact scenario causes additional damage to the leading edge with respect to the single UAS impact, with greater deformation of the front spar being observed.