1 April 2018 in Journal of Biomechanics
1 March 2014 in Journal of Biomechanics
1 June 2016 in Journal of Biomechanics
1 June 2015 in Journal of Biomechanics
4 April 2018 in Journal of Biomechanical Engineering
Although uniaxial tensile testing is commonly used to evaluate failure properties of vascular tissue, there is no established protocol for specimen shape or gripping method. Large percentages of specimens are reported to fail near the clamp and can potentially confound the studies, or, if discarded will result in sample waste. The objective of this study is to identify sample geometry and clamping conditions that can achieve consistent failure in the midregion of small arterial specimens, even for vessels from older individuals. Failure location was assessed in 17 dogbone specimens from human cerebral and sheep carotid arteries using soft inserts. For comparison with commonly used protocols, an additional 22 rectangular samples were tested using either sandpaper or foam tape inserts. Midsample failure was achieved in 94% of the dogbone specimens, while only 14% of the rectangular samples failed in the midregion, the other 86% failing close to the clamps. Additionally, we found midregion failure was more likely to be abrupt, caused by cracking or necking. In contrast, clamp failure was more likely to be gradual and included a delamination mode not seen in midregion failure. Hence, this work provides an approach that can be used to obtain consistent midspecimen failure, avoiding confounding clamp-related artifacts. Furthermore, with consistent midregion failure, studies can be designed to image the failure process in small vascular samples providing valuable quantitative information about changes to collagen and elastin structure during the failure process.
1 August 2015 in Journal of Biomechanical Engineering
Rotator cuff tears are a common problem in patients over the age of 50 yr. Tear propagation is a potential contributing factor to the failure of physical therapy for treating rotator cuff tears, thus requiring surgical intervention. However, the evolution of tears within the rotator cuff is not well understood yet. The objective of this study is to establish a computational model to quantify initiation of tear propagation in the supraspinatus tendon and examine the effect of tear size and location. A 3D finite element (FE) model of the supraspinatus tendon was constructed from images of a healthy cadaveric tendon. A tear of varying length was placed at six different locations within the tendon. A fiber-reinforced Mooney–Rivlin material model with spatial variation in material properties along the anterior–posterior (AP) axis was utilized to obtain the stress state of the computational model under uniaxial stretch. Material parameters were calibrated by comparing computational and experimental stress–strain response and used to validate the computational model. The stress state of the computational model was contrasted against the spatially varying material strength to predict the critical applied stretch at which a tear starts propagating further. It was found that maximum principal stress (as well as the strain) was localized at the tips of the tear. The computed critical stretch was significantly lower for the posterior tip of the tear than for the anterior tip suggesting a propensity to propagate posteriorly. Onset of tear propagation was strongly correlated with local material strength and stiffness in the vicinity of the tear tip. Further, presence of a stress-shielded zone along the edges of the tear was observed. This study illustrates the complex interplay between geometry and material properties of tendon up to the initiation of tear propagation. Future work will examine the evolution of tears during the propagation process as well as under more complex loading scenarios.