28 July 2021 in European Journal of Oral Sciences
The aim of this study was to assess the shear‐bond strength (SBS) of resin‐luting cement to experimental short fiber‐reinforced CAD/CAM composite (SFRC) compared to conventional CAD/CAM (Cerasmart 270), 3D printed (GC TEMP PRINT, Pro3dure GR‐17), and laboratory (Gradia Plus) composites. Moreover, translucency parameter values and light transmission were evaluated. For each of the five types of composites, discs were prepared (n = 16/group) and divided into subgroups (n = 8/group) according to surface treatment protocol (hydrofluoric acid or air‐particle abrasion). SBS test was performed using universal testing machine until failure, and failure modes were visually analyzed. Translucency parameter and curing‐light transmission values through 1, 2, and 3 mm thickness were quantified using spectrophotometry and the MARC resin calibrator, respectively. Scanning electron microscopy (SEM) was used to examine the CAD/CAM composites after surface treatment. Composite type and surface treatment had a significant effect on SBS. Laboratory composite showed the highest SBS value (22.4 MPa). Cerasmart 270 exhibited higher translucency parameter values (19.8, 11.0, 5.0) than SFRC (14.5, 5.2, 1.6) at the three composite thicknesses tested. Air‐particle abrasion was more effective in enhancing SBS than acid etching. Experimental SFRC CAD/CAM composite showed higher SBS values than Cerasmart 270. For all composites, translucency parameter values and light transmission decreased as thickness increased.
1 January 2018 in The Journal of Advanced Prosthodontics
Egilmez F, et al. J Adv Prosthodont. 2018 Feb;10(1):32-42. https://doi.org/10.4047/jap.2018.10.1.32
28 March 2019 in Dental Materials Journal
The aim was to evaluate the effect of different zirconia discontinuous fiber fractions on radiopacity and other selected properties of glass discontinuous fiber-reinforced flowable composite (Exp-SFRC). Exp-SFRC was prepared by mixing 30 wt% of resin-matrix and 45 wt% of particulate-fillers to 25 wt% of various weight-fractions of E-glass/zirconia discontinuous fiber-fillers (25:0, 20:5, 15:10, 10:15, 0:25 wt%). Flexural strength and fracture toughness were determined for each experimental material. Radiograph of each Exp-SFRC and aluminium step wedge were taken to determine the radiopacity. Degree of conversion and light-transmission were also measured. Scanning electron microscopy was used to evaluate the microstructure of the Exp-SFRC. Analysis of variance (ANOVA) revealed that fractions of E-glass/zirconia discontinuous fiber-fillers had significant effect (p<0.05) on radiopacity and other tested properties of the Exp-SFRCs. Replacing low fraction of E-glass fiber with zirconia fiber-fillers can increase the radiopacity of the fiber-reinforced composite without deteriorating the mechanical properties, although, degree of conversion was decreased.
1 September 2021 in The Journal of Prosthetic Dentistry
23 January 2021 in Clinical Oral Investigations
A Correction to this paper has been published: https://doi.org/10.1007/s00784-021-03798-8